Software Preparation - Panasonic CF-VDD283 Operating Instructions Manual

Software Preparation
(first time only)
Using the DVOROM Drive Pack in the MS-DOS Mode
To use the DVD-ROM Drive Pack in the MS-DOS mode, configure the drive following the
steps below after performing the preparations (Qf3 page 6, "NOTE"). If the steps listed
below are performed without completing the preparations first, the drive will not op¬
erate properly.
7 Click the [Start] button then select [Shut Down].
3
Select [Restart in MS-DOS mode] and click [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \(
Enter)
edit config.sys
CEnter)
Move the cursor to the line containing "OAKCDROM.SYS" and delete the characters
"rem" at the beginning of the line. (Deleting "rem" causes the item to become valid.)
DEV1CEH1GH=C:\W1ND0WS\C0MMAND\0AKCDR0M.SYS /D:MSCD000
(if this line is missing, add it.)
5
Press
C Alt j + ( F
) , thenC
SO
to save the file. Then press
(Alt ) +( F
). thenC
X
) to
exit the Edit program.
6
Follow the same steps to edit the "AUTOEXEC.BAT" file,
edit autoexec.bat (
Enter)
Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMANDVMSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8
9
Press
C5D +GD
, then
CD
exit the Edit program.
Restart the computer.
to save the file. Then press
C3D +QD
, then
CD
to
8