OMA 152-2699-4 User Manual page 10

17
ASSEMBLY
INSTRUCTIONS - CONTINUED
11
Half-tighten one hanger bracket screw,
remove one hanger bracket screw,
then push the canopy upwards and let
the hanger bracket screw head come
through the key hole slot, then rotate the
canopy counter-clockwise until canopy
is secured. Now, tighten hanger bracket
screws. Finally, push the canopy cover
upward, then turn it counter-clockwise
until it is secure.
12
Tighten fan blades to motor assembly by
using blade screws.
Mounting Plate
Mounting Screws
13
Remove the screw marked with a dot label which is preinstalled on the mounting plate
at the bottom of the motor assembly and retain the screw for later and slightly loosen the
remaining two screws. Assemble the switch housing to the mounting plate using the two
key slots in the switch housing. Replace the previously removed screw and securely tighten
all three screws.
05
Hanger
bracket
Hanger bracket
Canopy
screw
Key
hold slot
Canopy
cover
Blade
Blade screws
keyslot hole
Switch housing
18