Antenna/Cable Connections; Other Video Equipment; Care And Cleaning - Panasonic CT-27G32 Operating Instructions Manual

installatio=l (cont.)
Anten na/Cable Con nectior=u
Antenna Connection - For proper receptiolb ot VHI-/UHI- chaH_els, _r_ external
antenna is required. For best reception an outdoor antenna is recommended.
Antenna Mode must be set to TV. (Refer to Antenna Mode section.)
Incoming Cable from Home Antenna
Indoor Outdoor
Typical VHF/UHF Antenna
75 Ohm
VHF/UHF
on Back of Set
or
VHF/UHF
on Back of Set
300 Ohm
300 to 75 ohm Matching
Transformer (Not Included)
Cable Connection - For reception ot cabte channels, connect the cable supplied by your local cable company. Antenna
Mode must be set to CABLE. (Refer to Antenna Mode section.)
Incoming Cable from Cable Company
75 Ohm
VHFIUHF
on Back of Set
NOTE: Certain cable systems offset some channels to reduce interference ur have Premium (scrambled) channels. A
cable converter box is required for proper reception. Check with your local Cable company for compatibility
requirements.
Other Video Equipment
VCRs, Video Disc Players, Computers, TV games, and DSS equipment can also be connected to the antenna input
connection.
Care and Cleaning
Picture Tube (Turn set off)
Use a mild soap solution or window cleaner and a clean cloth. DO NOT USE ABRASIVE CLEANERS. Avoid excessive
moisture and wipe dry.
Plastic Cabinets
Wipe the cabinet with a soft cloth dampened with water or a mild detergent solution and wipe dry with a soft clean cloth.
Avoid excessive moisture. Do not use benzene, thinners or other petroleum based cleaners.
Wood Cabinets
When dusting or polishing the cabinet, use a clean soft cloth and stroke straight with the grain. An occasional coat of
furniture polish will help preserve the finish. Do not use benzene, thinners or other petroleum based cleaners. Do not
place obiects made of plastic or rubber directly on top of the cabinet. A chemical reaction could result causing permanent
marring of the finish.
Remote Control Transmitter
Do not use benzene, thinners or other petroleum based cleaners to clean the Remote Control Transmitter. To clean, wipe
with a so_t cloth slightly moistened with a mild detergent and then wipe dry with a soft clean cloth.
--6--