Advertisement
4.5
Turning MULTI TIMBRE on and off
The MULTI
TIMBRE
function allows external MID! instruments operating on different channels to simultaneously use up to 16
tone colors. The following chart gives the channel number assignment.
Channel
6
FULL ORGAN
Channel 12
: JAZZ GUITAR
a
Procedure
1) Make sure that the digital piano is in the programming mode. (See p. 7 4.1 "Entering the programming mode".)
2) Press the PIANO 2 switch to set the LED next to the PIANO 2 switch flashing.
3) Press the highest black key to turn the function off, the highest white one to turn it on.
4) Leave the programming mode.
(See p. 7 4.2 "Leaving the programming mode"'.}
Notes: e When the power is first applied or reapplied after a short break, MULT! TIMBRE
is off.
e SPLIT function transmits MIDI messages for the upper half of the keyboard on the current MIDI channel or, if no channel
has been selected, channel 1. Those for the lower half go out over the next channel.
=
Example
If the current MIDI channel is 3, the upper half of the keyboard sends on channel 3 and the lower half sends on channel 4. If the
current channel is 16, the lower half sends on channel 1.
4.6
Turning LOCAL CONTROL on and off
LOCAL
CONTROL
refers to the connection
between the internal sound source and the keyboard.
It is normally on.
Turning it
off disconnects the keyboard; the instrument sounds only when it receives keyboard data through the MIDI interface.
The key-
board can still control other MIDI devices connected to the P360's MIDI OUT.
=
Procedure
1) Make sure that the piano is in the programming mode.
(See p. 7 4.1 "Entering the programming mode"'.}
2) Press the E PIANO 1 switch so that it flashes to indicate that the interface is waiting fora LOCAL CONTROL specification.
vt,
e
Flashes.
O
O
NZ
O
O
O
—
r=
e
JAZZ
FULL
PIANO
PIANO
E:
E-PIANO
ORGAN
ORGAN
CHORUS
1
2
2
3) Press the highest black key to turn it off the highest white one to turn it on.
4) Leave the programming mode.
(See p.7 4.2 "Leaving the programming mode".)
Note:
Momentarily turning off the power also turns LOCAL CONTROL on.
OFF
ON
2) Tuning
1) Make sure that the digital piano is in the programming mode.
(See p.7 4.1 "Entering the programming mode"'.)
2) Press the E PIANO 2 switch so that it flashes to indicate that the piano is ready to be tuned.
ty,
a
Flashes.
ads
O
o
O
`%
0
O
=
JAZZ
FULL
PIANO
PIANO
E-PIANO
E"
ORGAN
ORGAN
CHORUS
1
2
1
le «-- Flashes.
3) Untike the other functions in the programming mode, this one produces keyboard output so that you can compare the piano's
pitch with another instrument.
It uses the same keys as the LOCAL CONTROL function.
4) Press the highest black key to lower the pitch, the highest white one to raise it. It may
be necessary to press these keys repeatedly to achieve proper tuning.
DOWN
UP
Advertisement
