MAD AMPX PRO ESC 30A Manual

AMPX PRO ESC 30A
2~6S
Electronic Speed Controller manual
Disclaimer
Thank you for choosing this product. Please carefully read this manual before using this product. Using this product will indicate you're agreed
with the all items in this manual. Please strictly follow these items during usage. We'll not commit any responsibility including but not limited to
indirect loss or joint responsibility caused by improper usage, private modification and other faults. The maximum compensation will be not
more than the cost of product itself.
Attention
This part has strong power. High speed running propellers have certain safety risk. User must be older than 18 years and have relative
professional knowledge.
Before usage, please carefully check if all the components are in good conditions.
Features
New core software for quadcopter esc with improved throttle response.
Excellent compatibility with more poles type motors like MAD motors.
Default middle timing meet almost all brushless motor.
Crosstalk reduction of signal transmission.
Compatibility with wide range of flight controllers Signal frequency above 600HZ.
Protection Function
Over Current Protection
Once checking current is more than 40A and lasts 3 seconds, ESC will shut off power output, and will resume normal after making throttle zero.
Short Circuit Protection
Once checking instant current is more than 60A, ESC will power off, and will rework after trouble shooting and powering again.
Stalling Protection
Motor stall will trigger stalling protection. ESC will resume after making throttle zero and powering again.
Voltage Protection
Once checking voltage is less than 16V or more than 64V, ESC will alarm and will not start up motor. But it will be out of effect during flying.
Temperature Protection
When checking temperature is higher than 110 centigrade degree, ESC will output error signal. Once temperature exceeding 140 centigrade
degree, ESC will shut off and will resume normal after making throttle zero.
Throttle Loss Protection
When the detected throttle signal is lost for more than 0.3 seconds, the ESC will automatically shut down. After the throttle signal is restored,
the ESC will work again
Start Protection
When the motor is not started after increasing the accelerator for 10 seconds, the ESC will automatically shut down. After the accelerator is
reset to zero, and the accelerator is pushed again, the ESC will return to normal.
Throttle Calibration Setting
First connect motor and adjust throttle top, then power on and ESC will beep two times. Second adjust throttle bottom and ESC will Do Mi So
one time. After finishing these steps, throttle calibration will be set successful.
V1.0