Motorola iDEN i930 Field Service Manual page 33

DISPLAYS, MESSAGES, AND ALERTS: Using the Optional Vibrate Function
Table 3-4. Alert Tones (Continued)
Tone Low
Voice Mail Spkr
Received in Idle
Voice Mail Ear
Received in
Interconnect
3.5 Using the Optional Vibrate Function
The vibrate function (VibraCall) notifies the user of incoming phone or dispatch calls, messages,
notifications, and call alerts.
If the unit is set for Vibrate in any mode, it will vibrate for 1/2 sec during the power-up sequence.
To set unit to vibrate for all calls:
1. On the Home screen, select Start
2. Select Settings and then Vibrate All.
3. Select Use Vibrate All.
4. Select Done.
The following table describes the cadence for each vibrator mode:
Table 3-5. Vibrator Settings
Mode
Vibrate All or Selectable Vibrate
Ring Tones
Off
To set unit to vibrate for Direct Connect and Group Connect calls only:
1. On the Home screen, select Start.
2. Select Settings and then Notifications.
3. In PTT, scroll right or left to select Ring, Vibrate or Off.
4. Select Done.
3-6
High Freq Cadence
Spkr 2400/ 8x(64ms on 2400Hz + 64ms on
2743Hz 2743Hz) every 30 seconds
Ear 2400/ 8x(64ms on 2400Hz + 64ms on
2743Hz 2743Hz) every 30 seconds
Cadence
2x(500ms on, 500ms off) + 500ms on + 2.5 sec. off
Three Vibrate Only cadences, followed by an audible ring tone until
answered or party hangs up
Turns off the vibrator function
When Tone Occurs
Voice mail received while unit is
idle
Voice mail received while unit is
in interconnect mode
68P80401P03-O