Table of Contents
Advertisement
16 Operation
Designs A0, AE, AP, E1, E2:
- The actuator is reversible, i.e. it can be switched directly
from "OPEN" to "CLOSED". To this end, a dead zone of 200
ms is integrated into the electronic system, i.e. when
switching over, the actuator does not run for this time.
- Independent of the supply voltage, the OPEN/CLOSE control
is freely selectable via a mains supply of 24 V DC, 24 V AC
up to 250 V AC or operated directly via a PLC.
- An electronic current limitation limits the torque.
- For the above actuator types (except for code 2070), overall
height 2 applies (see chapter "Dimensions").
Risk of electric shock!
▶ Risk of injury or death (if operating
voltage is higher than safe extra low
voltage).
▶ Adjustments are made with the actu-
ator cover removed.
▶ Electric shock can cause severe burns
and fatal injury.
Always disconnect the product from
●
power supply!
Therefore, have all work performed
●
only by qualified electricians.
16.3 Operation - Third-party actuators
For more detailed information on third-party actuators, refer
to the manufacturers' documentation
GEMÜ R478 Tugela
DANGER
48 / 56
www.gemu-group.com
Advertisement
Table of Contents
