Pioneer CT-S88R Service Manual page 11

CT-S88R
4, Remove The FL Unit 4. Remove The Switch Unit
Undo two setscrews at the top and then disengage the two hooks Undo the one screw securing the switch unit, and then dis-
projecting from the inside of the front panel. engaging the two hook catches and the two inserting sections,
pull the unit out toward the rear.
1, Remove The Bonnet (See page 6.) 1. Remove The Bonnet (See page 6.)
2. Remove The Door (See page 6.) 2. Remove The door (See page 6.)
3. Remove The Front Panel (See page 6.) 3. Remove The Front Panel (See page 6.)
4. Remove The VR Unit
Undo the two screws securing the VR unit.
VR Unit and Operation Switch Unit Removal Operation Panel Removal
4. Remove The Operation Panel
Straighten the operation panel holding bends from the rear of
the front panel, and remove the operation panel (struck by the
dual-sided adhesive tape).
5. Remove The Operation Switch Unit
Undo the three setscrews, and then remove the unit from the
button holder by swivelling towards the rear.
(@ Undo the three screws securing the button holder.)
Note: If the operation panel is removed, it is not used again.
Operation switch unit
VR Unit
41