Important; How It Works - Profi-pumpe Profi-AirBrush Gravity-ERGO 1035 D 0.38 Operating Instructions Manual

4. Important note: please pay attention before commissioning the airbrush!
l The air hoses for airbrush guns are air-tight. Sealing of the screw connections can be carried out with Teflon tape. The
rubber seals are to be checked regularly and replaced if necessary.
l Connect the air hose, the airbrush gun to the 1/8 „port on the compressor fitting.
In order to avoid leaks, the screw connection of the air hose should always be sealed with Teflon tape.
l Before starting up, especially after cleaning or after repairs, check the tightness of all connecting elements as well as the
tightness of the unit and the hoses..
l Please, note that in dependence of the device used (compressor/gun) the color must be diluted.
l Your airbrush gun must be cleaned thoroughly after each color change, otherwise the residual color mixes with the
newly filled color.
Moreover, the very fine nozzle will be clogged by dried ink. The gun should be cleaned with thinner and water.
Especially the nozzles, which are subject to wear, will have longer lifetime by careful cleaning .
l Please, inform yourself in the literature or on the Internet about the working methods and techniques before
starting work .
l Please, check the funktion of the gun with clean water. Is the function correctly given, the technology of the gun
is perfect.
l Please connect compressor, hose and gun always tight. Avoid oscillatingly opening (constant on and off) of the
compressor in order to reduce wear and to save energy.
l We sell only tested products. These are strictly for personal use.
l Claims for damages for improper disassembly and cleaning can not be accepted.
l Complaints about contaminated airbrush guns with paint,residues, could not be recognized.

5. HOW IT WORKS

5.a The airbrush gun is a two-stage atomizer according to the principle of a jet pump using compressed air as a
propellant. With the airbrush gun, any liquid paint with fine pigment, suitable for airbrush guns, can be applied to all
substrates, depending on the nozzle size. Acrylic paints, watercolor paints, textile paints and dilute oil paints are easy
to apply. The working pressure is usually between 1.5 and 3 bar. The higher the pressure is set, the finer the ink is
atomized. In order to deliberately create uneven surfaces, e.g. In order to display sand, one can set the pressure
very deliberately very low.
Dual-Action Gun: With one lever, the amount of air as well as the amount of paint can be regulated at the same time.
Semi-Dual-Action: Separate airflow and color control in two areas. Activation via pressure point.
Bedienhebel
Bedienhebel
1
Farbmengenregulierschraube
3
Farbmengen-
regulier-
schraube
English 3
3
Bedienhebel
Farbmengenregulierschraube
1,2
2