Advertisement
Device button
functionality
Activate the device
During setup within the JoJo Monitor
App you will be prompted to activate
your device and link it to your account.
To do this, press the button on your
device once. Upon release you will hear
4 long beeps followed by 1 short beep
to confirm that it has been activated.
If you only hear 1 beep, the device is
already activated and ready for use.
Put the device in test mode
We recommend using test mode while
installing your device to ensure proper
functionality. Simply follow these steps:
Enter test mode
Press and hold the button for 5 seconds
until you hear 2 long beeps.
Test your sensor alignment
While in test mode, check that your
sensor is level and properly aligned.
The buzzer is influenced by alignment
and will sound with periodic beeps to
indicate the signal quality with
indications as follows:
Bad signal = 3 seconds between beeps
Good signal = fast consecutive beeps
Exit test mode
Press the button once. If the button
is not pressed the device will remain in
test mode for 10 minutes, after which
test mode will automatically conclude.
Device battery status
Your device battery status will be
visible on your device dashboard at
all times and indicated as follows:
REPLACING BATTERIES
01
Use a 3mm hex Allen key to
remove the four screws in the
corners of the monitor device.
02
Remove the back cover and
replace the batteries as per the
orientation indicated. Note: It is
advised to only use 3.6v lithium
AA batteries and to not use old
and new batteries together.
03
Close the cover, place the four
screws back in place and firmly
secure them with the allen key.
Advertisement
