Advertisement
PRE-INSTALLATION
Important:
Before installing the device on top of your tank, please download the JoJo Monitor
app and follow the prompts to link your device to your account. This requires you to activate your
device, and enter your device specific serial number which is on the back of your device.
Scan this QR code
to download the
Or visit
INSTALLATION
01
Refer to the placement recommendations provided to find the best location to install your
Tank Level based on your tank type. Note: If your tank type is not mentioned, it is advised to
find the highest, most level point on your tank for the most accurate readings.
02
Attach the 40mm hole saw bit to your drill and drill a hole in the recommended location.
Important: Once done, clean the area in and around the hole to remove any plastic shavings.
03
Before installing the sensor (A) you will need to first remove the locking ring (A3) by unscrewing it
anti-clockwise and lifting it up. This will give you access to the screw holes in the mounting bracket (A2).
04
Secure the mounting bracket (A2) in place by using 3 of the self-tapping screws (2) provided. You can
use the built-in spirit level as well as test mode to ensure that your sensor is level and properly aligned.
05
Once you are sure that your sensor is level, it is important to lock it in place to ensure it does not
shift. To do this, put the locking ring (A3) over the mounting bracket (A2) and turn it clockwise.
06
Once the sensor (A) is secured, you can secure the monitor device (1) in place with either the
2 remaining self-tapping screws, the double-sided tape (attached to the back), or the cable ties.
IMPORTANT INFORMATION
To ensure proper device operation and communication please take note of the following:
Never place your device inside metal or concrete containers, enclosures or confined spaces.
Do not fully enclose or submerge the unit as this could have an impact on its performance.
For best accuracy, it is advised to have a minimum gap of 150mm between your highest
possible water level and your sensor.
The measurable range of the sensor is from 150mm to 5 000mm.
It is recommended to install your sensor as close to the centre of the tank as possible to
avoid interference with the side wall as that could result in inaccurate readings.
Remote monitoring signal coverage is hampered when installed indoors, underground, or within
a basement of a building and, as a result, limits communication between the device and network.
JoJo Monitor app
www.jojo.co.za/jojo-monitor-devices
and set up your device.
for more info.
Advertisement
