Table of Contents
Advertisement
GRAPHIC EQUALIZER CONTROLS
The advantage of the GRAPHIC EQUALIZER over conventional tone
controls is that with the five controls of the GRAPHIC EQUALIZER it
ble to control five different narrow, distinct sections of the audio
band width by up to + 7 dB. With conventional tone controls a set-
ting for a bass or treble boost or cut will also affect the jower or upper
mid frequencies.
The frequency
bands controlied by the five slide
controls have been chosen to yield the maximum
possible control action
within the audio spectrum,
BASIC OPERATIONS
100 Hz:
The 100 Hz controlis very useful in enhancing low bass notes
as in organ musie.
330 Hz:
The 330 Hz contro! will allow you to vary the upper bass
frequencies.
TkHz:
The 1kHz control is the presence control and can be used
very effectively to emphasize, or de-emphasize vocalists.
3.3kHz:
The 3.3 kHz control wil add brilliance and clarity ta brass
instruments and violins.
10 kHz:
The 10 kHz contro! can be used to make up for missing high
frequencies absorbed by the environment and to add a natural
crispness
to music.
Press the rear MAIN POWER switch to the on position.
SETTING THE TIME
i is only necessary to adjust the time if the time is incorrect.
. Press the CLOCK ADJ button,
. Use the
~"" and ''+"" buttons to set the hours.
. Press the SET button.
. Use the "'-'" and '+' buttons to set the minutes.
. Press the SET button when "00" seconds of that minute are
reached.
VPWNH
A
ABOUT THE FUNCTION SWITCH
Select the FUNCTION switches before operating any of the equipment.
F-291 {L), DC-281
)
Auto Function ' pp.z71, pp-ze1m
This rnodel is equipped with the ''auto function" operation, so when
the switches
for playing the CD, tape, or tuner are pressed,
the
amplifier's function switches automatically. However, the deck or other
connected
equipment
will continue
to function,
so stop them
if
necessary.
LISTENING TO THE BROADCASTS
sonny
[ F-z91
Auto tuning
1, Press the cassette
tape deck amplifiers POWER
switch to
the an position.
2. Select the desired broadcasting band using the BAND selector
switch.
3. Press the AUTO/MANUAL
switch to establish the auto tuning
mode (the AUTO indicator will light).
4. Press
the ''+'' of "'-"' TUNING
switch
for higher or lower
frequency.
The frequency will change rapidly during scanning. The auto tuning
will stop automatically when the station is located and the TUNED
indicator wilf fight up.
NOTE:
When the auto tuning is in use, reception may not be possible over fong
distances or when signals are weak.
Al these times manual tuning is
recommended.
5. Adjust volume with the VOLUME control and the tone with the
GRAPHIC EQUALIZER controls.
44
<ARBIIO0>
Manual tuning
1. Press the cassette
tape deck amplifier's POWER
switch to
the on position.
2. Select your desired broadcasting band using the BAND selector
switch.
3. Press the AUTO/MANUAL
switch to establish the manual tuning
mode (the AUTO TUNING indicator goes off).
4.
Press the TUNING switch to locate the frequency of your desired
station.
For step-by-step searching, press the TUNING switch once and re-
lease it Immediately. For continuous rapid scanning keep the TUNING
switch pressed. The TUNED indicator will light up when the sta
Uon is tuned in best.
F-Z94L
2, Select your desired broadcasting band using the BAND selector
switch.
3. Press the TUNING switch to locate the frequency of your desired
station
For step-by-step searching, press the TUNING switch once and re-
lease it immediately. For continuous rapid
nning keep the TUNING
switch pressed,
The
TUNED indicator will light up when the sta
tian is tuned tn best.
NOTE:
The TUNED indicator will nat function for broaticasts received aver tong
orstances or when signals are weak
4. Adjust the volume with the VOLUME
control and the tone with
the GRAPHIC EQUALIZER conuols.
PRESETTING
STATIONS
Presetting
From
1 to 24 FM/AM
stations can be preset at random.
Press the
STATION CALL
switch once for 1
12 (Mode 11 and twice for 13 -
24 (Mode 2}.
7. Tune in desired station.
2. Press the MEMORY
switch
* The disptay will flash (about 10 seconds)
MEMORY
"
Frequency
display
Advertisement
Table of Contents
