Table of Contents
Advertisement
en Appliance care
Clean the filter in the condensation
3.
container.
15.2 Calling up the appliance
care programme
Requirement: The appliance care
programme is ready.
→ "Preparing for appliance care",
Page 35
Set the programme to position 1.
1.
Press and hold
2.
set the programme to position 4.
Release
Iron Dry .
3.
a "CP1" and the programme dura-
tion alternate on the display.
15.3 Running the basic appli-
ance care programme
To remove any dirt deposits in the
appliance, you can run the basic ap-
pliance care programme.
Notes
¡ The basic appliance care pro-
gramme runs for approximately
1 hour.
¡ After a lengthy period of use, the
appliance reminds you to run the
basic appliance care programme.
Before the programme starts or
after the programme has ended,
the display shows the notification
"CrE" . This notification appears re-
36
Iron Dry and
peatedly until you have run the ba-
sic appliance care programme
through to the end.
Requirements
¡ The appliance care programme is
ready.
→ "Preparing for appliance care",
Page 35
¡ The appliance care programme is
now called up.
→ "Calling up the appliance care
programme", Page 36
Pour approx. 1.5 litres of hot
1.
mains water into the condensation
container.
Hold the filled condensation con-
tainer level so that no liquid spills
out.
Insert the condensation container
2.
so that it locks into place.
Press
Start/Pause .
3.
a The appliance care programme
starts and a signal tone sounds.
a "End" appears on the display and
a signal tone sounds once the ap-
pliance care programme has
ended.
Pull out the condensation con-
4.
tainer horizontally and empty it.
→ "Emptying the condensation
container", Page 32
If you are draining the condensa-
5.
tion water using the drain hose:
Remove the stopper from the
‒
underside of the condensation
container.
Insert the stopper into the re-
‒
cess on the top of the condens-
ation container.
Insert the condensation container
6.
so that it locks into place.
Advertisement
Table of Contents
