Parameters Setting; Battery Parameters - Offgridtec MPPT PRO-X Series User Manual

5.

Parameters Setting

5.1. Battery Parameters

5.1.1. Supported battery types
1 Lead Battery
2 Lithium Battery
3 Custom (USE)
Note: If the controller supports 48V system voltage, the battery type will display LiFePO4 F15/F16
and Li (NiCoMn) O2 N13/N14.
5.1.2. Local setting
When the default battery type is selected, the battery voltage parameters cannot
be modified. To change these parameters, select the "USE" type.
WARNING
Step1：Enter the "USER" battery type.
Detailed operations of entering the "USE" battery type are shown in the following table.
content operation steps
1)
2)
enter the "USE"
battery type
3)
4)
sealed (default)
gel
flooded
LiFePO4 (4S/8S/15S/16S)
Li (NiCoMn)O2 (3S/6S/7S/13S/14S)
Press the button to browse the battery parameters on the initial
interface. Press the
interface, and long-press the
interface.
Press the or
the battery type as F04. And then press the
Continue to press the
automatically go back to the battery parameters setting interface.
Long-press the button to enter the battery-type interface again on the
battery parameters setting interface.
Press the or
— 18 —
MPPT PRO-X 10A | 20A | 30A | 40A
button to enter the battery parameters setting
button to enter the battery-type
button to select the battery type, such as select
button twice or wait for 10S of no-operation to
button to select the battery type "USE."
button to confirm.