Advertisement
4. OPERATION
WARNING! DO NOT connect unit to the mains power supply before installation.
4.1.
INSTALLATION
4.1.1.
Give careful consideration to the position of unit to ensure you obtain maximum benefi t from the lighting range, and that an
appropriate electrical power source can be provided.
4.1.2.
An approximate appropriate mounting height from the ground is 2.5m. See fi g.1.
4.1.3.
This LED fl oodlight develops minimal heat and is not subject to the same mounting restrictions that apply to halogen lamps that
become too hot to touch. We do however recommend that the fl oodlight should not be placed in cramped or restrictive positions
and should be fi xed at the following minimum distances between the light and any surface/object. See fi g.2.
● 500mm minimum between the top of the light and any overhead surface, or objects, i.e. ceilings, overhangs.
● 200mm between sides of light and wall/surfaces.
● 2 metres minimum between the front of the light and any object to be illuminated.
Fix the light to a vertical surface with appropriate fi xings.
Ensure the lamp is connected to the mains by a qualifi ed electrician.
4.2.
SENSOR
The sensor may be angled independently of the light. Mounted at approximately 2.5m above the ground the sensor will have
approx 12m range (fi g.1) with a 120º spread (fi g.3)
4.2.1.
The sensor range can be reduced or optically adapted to local conditions by adjusting the sensor angle accordingly.
4.2.2.
Further adjustment may be made by tuning the three switches located on the underside of the sensor as follows: (fi g.3).
4.2.2.1.
Switch SENS: Sensitivity. The sensor range will vary with temperature and factors such as passing cars, shade from large trees
etc. During cold weather the sensor range will be greater than when hot in summer temperatures. For example during hot weather
the forward detection range could fall from 12 to 6m and the sensor should be checked and adjusted. Note: the sensitivity factor is
greater when an object passes across detection area (fi g.3A) than when an object approaches towards the detector (fi g.3B).
4.2.2.2.
Switch TIME: Time adjuster: To adjust the amount of time the light will stay on when activated.
4.2.2.3.
Switch LUX: Daylight adjustment: To adjust the sensor to come on in accordance with the diminishing daylight.
fi g.1
5. MAINTENANCE
5.1.
Clean the casing externally (not the glass) with a moist cloth.
DO NOT use solvents or abrasives to clean the light.
5.2.
Avoid touching the glass shield as handling may reduce its serviceable life and cause the glass to crack. If necessary clean the
glass shield with alcohol and a soft cloth.
5.3.
DO NOT use the light without the glass shield.
DO NOT use the light without the weather seals intact.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call our
technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 24 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fi g.2
01284 703534
Original Language Version
fi g.3
sales@sealey.co.uk
LED112PIR.V2, LED113PIR.V2, LED115PIR.V2 Issue 1 23/12/21
www.sealey.co.uk
Advertisement
