Beta 1875LT Instructions For Use Manual page 29

Cleaning the detergent filter and the spray-suction tool
• After washing check that the filter (f) situated on the detergent solution suction hose
is not blocked; if it is, remove it and flush with running water (fig. "F9").
• If dirt is deposited inside the spray extraction nozzle (r), remove the transparent
part on the top (t) to clean it (fig. "F10").
DIFFICULTIES?
PROBLEMS
- - - - - - - - - - - - - - - - - - -
• The appliance won't
start.
- - - - - - - - - - - - - - - - - - -
• Dust is blowing out of
the safety grills .
- - - - - - - - - - - - - - - - - - -
• Reduced efficiency.
- - - - - - - - - - - - - - - - - - -
• The rpm rate of the
motor is noticeably
higher.
- - - - - - - - - - - - - - - - - - -
• The water/detergent
solution is not spraying
evenly.
CAUSES
- - - - - - - - - - - - - - - - - - - - -
• No power.
• Defective power cord,
switches or motor.
- - - - - - - - - - - - - - - - - - - - -
• Dirty filters.
• Dust collection bag full or
torn.
• Cartridge filter element
saturated or worn.
- - - - - - - - - - - - - - - - - - - - - -
• Drum is overfull.
• Dust collection bag full or
torn.
• Cartridge filter element
saturated or worn.
• Clogged tube or
attachments.
- - - - - - - - - - - - - - - - - - - - -
• Drum is overfull.
• Dust collection bag full or
torn.
• Cartridge filter element
saturated or worn.
• Clogged tube or
attachments.
• Safety float triggered.
- - - - - - - - - - - - - - - - - - - - -
• The filter on the detergent
solution suction hose is
clogged.
• The spray extraction nozzle
is clogged.
SOLUTIONS
- - - - - - - - - - - - - - - - - - - - -
• Check that the power supply
is on.
• Contact Beta Utensili S.p.A
- - - - - - - - - - - - - - - - - - - - -
• Replace them.
• Replace it.
• Replace only the filter
element.
- - - - - - - - - - - - - - - - - - - - -
• Check the drum container.
• Replace it.
• Replace only the filter
element.
• Check the hose or
attachments.
- - - - - - - - - - - - - - - - - - - - -
• Check the drum container.
• Replace it.
• Replace only the filter
element.
• Check the hose or
attachments.
• Empty the container-drum.
- - - - - - - - - - - - - - - - - - - - -
• Remove the filter from the
tube and rinse it under
running water.
• Disassemble and clean the
nozzle by submerging it in
a glass containing vinegar
or limescale remover (fig.
"G1").
EN
29