Beta 1875LT Instructions For Use Manual page 26

EXTRACTION WASHING
Always remove the filter element (if available) and the paper filter
1d - PREPARING THE APPLIANCE
Dosage
• Insert the diluted detergent according to the dispositions of
the producer until reaching the indicated "MAX" capacity
level (fig. "D1a").
• Insert the container into the drum (fig. "D1b").
• Insert the detergent mixture suction hose (i) in the hole
in the tank (s) (Fig. "D2").
2d - ASSEMBLING THE DISPENSER UNIT
• Unscrew the knob (p) (fig. "D3").
• Fit the dispenser unit (e) on the ergonomic grip (9) and lock it into place in the side
guides (h) (fig. "D4").
• Screw the knob (p) back in tightly (fig. "D5").
3d - ASSEMBLING THE HOSES
• Use the clamps (15) to run the liquid detergent hose (16) along the flexible hose
(14) (fig. "D6a").
• Plug the male rapid fitting attachment (4) into the female rapid fitting attachment
(5) (fig. "D6b").
• Press the front ring (6) to release it (fig. "D6c").
• Then attach the accessories and the detergent liquid feed tube, more precisely:
1- the end (7) of the flexible hose into the air inlet (8) (fig. "D7a").
2- t he ergonomic grip (9) into the extension wands (10) (fig. "D7b").
3- t he extension wands (10) into the spray extraction nozzle (11) (fig. "D7c").
4- the detergent solution hose (12) (attached to the nozzle "11") into the dispenser
unit (13) already attached to the ergonomic grip (9) (fig. "D7d").
26
bag (if present)! Use the foam filter (Fig. "B6").
1 dose