Advertisement
Thank you for choosing av:link PJM620 ceiling projector bracket. This bracket allow device up to 8kg in weight to be mounted on ceiling safely.
Designed to be easily installed and supplied with all required installation hardware.
Caution:
Please read this manual thoroughly to avoid damage to property or personnel. If unsure in any part of this manual please refer to professional installer
for help:
-
This product contains small components that could be choking hazard if swallowed, please keep away of reach from Children.
-
This product is designed for mounting on concrete or plastered ceiling. Always ensure the mounting surface will be capable to withstand the
combined weight of the bracket and device, reinforcement may require for aged or weak ceiling.
-
Safety gear such as glove and safety goggles must be worn during the installation. Minimum of two people are required throughout the
installation, failure to do so may result in injury or damaged property.
-
This product is design for indoor use only, joint parts must be inspected at minimum of every two month for loose joint or aged parts.
Contents:
Please check all contents list below are included inside the box and return to retailer or dealer if components missing.
For this installation you will also require pencil, tape measurer, electric drill, stud finder and Philip (cross) screw driver.
Adjustable Ceiling Projector Bracket
Item ref: 129.581UK
PJM620
User Manual
129.581UK User Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AVLink PJM620
Summary of Contents for AVLink PJM620
- Page 1 Item ref: 129.581UK User Manual Thank you for choosing av:link PJM620 ceiling projector bracket. This bracket allow device up to 8kg in weight to be mounted on ceiling safely. Designed to be easily installed and supplied with all required installation hardware.
- Page 2 Step 1– Assemble 1, Slide the outer drop pole over the inner drop pole and fit the nylon and metal grip as show in fig 1 below. 2, connect the outer drop pole to the ceiling mount as show in fig 2 below. The tapped square washer goes inside of the outer drop pole and screwed through the slit and screw hole as shown.
- Page 3 Step 3 – Slide the bracket arm in and out until the mount holes are lined up with the projector, used supplied M4, M5 or M6 screw and plastic spacer to fit the projector on to the bracket. Hook the projector mount on to the drop pole as show below. Adjust back/forth/side tilt, Pan, and drop angle until desire position is achieved, lock the position up by tightening the hex screw use supplied allen key.
Need help?
Do you have a question about the PJM620 and is the answer not in the manual?
Questions and answers