Advertisement
SAFETY INSTRUCTIONS - PART B
-
E N G L I S H
-
•
The manufacturer advises the correct use of Luminaires (lighting fixtures)! Therefore always follow
these instructions to ensure correct and safe installation and functioning of the luminaire and keep
it
for
future reference.
• Turn off electrical power at main fuse or circuit breaker box before commencing installation,
maintenance or repair.
• If in doubt, consult a qualified electrician or contact your retail outlet. Ensure that you always install the
luminiare to the local electrical code. Certain regulations indicate that luminaires should be installed by
a qualified electrician.
• Observe the correct color of the wiring before installation: white (N), black (L) and green or bare
copper wire (Ground).
• Do not connect this luminaire to a non-grounded electrical system.WARNING: Installing this fixture
in
a non-grounded electrical system could allow metal parts of the luminaire to carry electrical current if
any wires or wire connections become broken or loose. Under this condition, anyone coming in contact
with the luminaire is subject to electric shock which could cause injury or death.
• Always use wire nuts/connectors rated for the correct gauge and number of wires used. CAUTION:
Be
certain that no bare wire strands are exposed outside of the wire nuts/connections (if applicable).
•
Be
careful not to damage or cut the wire insulation ( covering) during installation. Do not permit wires
to contact any sharp edges.
•
Do not remove thermal insulation pad(s). Doing so will result
in
increased temperatures and possible
risk of fire.
• Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents.Avoid liquid on all
electrical parts.
• Always consider all the technical specifications of the luminaire.Verify the stated icons on the
identification label on the luminaire and the icons that are shown in part A of your safety instructions.
ATTENTION: Below you will find all the explanations with numeric reference to the
icons
respec-
tively in front of these PART-B safety instructions. Applicable icons to your fixture are shown in
PART-A safety instructions.
01- This luminaire should only be installed indoors.
02- The luminaire is suitable for outdoor usage.
03- Only suitable for dry locations.
04- Suitable for damp locations.
OS-
Suitable for wet locations.
06- Luminaire is suitable for base up mounting.
07- Luminaire is suitable for base down mounting.
08- Luminaire is suitable for horizontal mounting.
09-The luminaire is only suitable for fixing to the ceiling.
I 0- The luminaire is only suitable for fixing to the wall.
I 1-The luminaire is suitable for fixing to the wall and to the ceiling.
12- Always observe the minimum distance between the lamp and the surface being lit as
indicated
on the icon.
13- Free air space of at least
4
inches must be kept between top of shade and bottom of canopy.
14- Immediately replace a cracked or broken safety glass and use only manufacturer approved parts.
15-
Strip the wire as indicated in the diagram.
16- Use heat-resistant cable for wiring the luminaire into the mains.
17- MAX
....
W:only use lamps suitable for this luminaire and keep within the maximum specified wattage.
18-This product is not suitable for children under 14 years
19-The Luminaire has a ground conductor identified with green insulation or bare copper wire
..
20- The luminaire is only suitable for a lamp with built-in safety or a low pressure lamp.An
extra
safety
glass is not necessary.
21- Capsule and linear halogen lamps may not be touched by bare hands.
22- The luminaire is equipped with a fuse. If the luminaire is out of order aker the bulb has been replaced,
the internal fuse has to be replaced. If contact with the internal wiring can be made during this opera-
tion, this should be done by a competent electrician.
23- The luminaire can be used with a dimming circuit. Consult a qualified electrician for choosing the right
type (especially important for low voltage luminaires).
24- The Luminaire cannot be used with a dimming circuit.
25- The luminaire is dimmable with the supplied dimmer ONLY. Do not connect to an additional dimmer.
26- The dimmability features depend on the chosen lamp. More information on the dimmability features
is
available in the information pack provided with the bulb.
27- Luminaire with time and light setting options. Minimum and maximum will be shown in the icon in partA
28- The luminaire can be placed at a maximum of 20k height.
29- To reach an optimal working, you have to place the luminaire on the height mentioned in the icon.The
maximum and minimum reach of the detector is also mentioned in the icon in partA
30- The standard active range of vision of the detector covers the given degrees mentioned in the icon.
31- Ensure that you don't drill through electrical wires or any other obstruction
in
the wall or ceiling
during installation!
32- This luminaire contains in some places very hot parts.
33- Product to be installed by two people.
34- The product is for indoor use only. Do not use in wet locations, areas directly exposed to water or outdoors.
35- The product is ZigBee certified. Zigbee is an open standard for indoor wireless communication. All Philips ZigBee
Certified products can be connected with other Philips ZigBee Certified products.
36- Bluetooth
9
enabled product. The Bluetooth" word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by
Signify
is under license. Other trademarks and trade names are those
of their respective owners.
Signify warrants that this device will be
free
from defects
in material
and
workmanship and will operate for 2 years, unless a
different
period
is stated in or on the pacl<aging
of the product, based
on up
to
3 hours average working time per
dayfl days
per
week,
when
used as directed.
If
this device
does
not
conform
to
the
warranty,
Signify will send you, at
its election,
a
replacement
device or refund your
original
price upon receipt
of the
returned device,
register
receipt
and
proof
of
purchase. Please call our
toll-free
number,
1.aJ0-555-0050,
or write
to
us
(address indicated on
the
pacl<aging)
to
find out how
to
rewm the device. This
limited
warranty does not
cover devices subject
to
accident,
neglect, abuse,
misuse or
acts
of
God. REPLACEMENT OR
REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED
WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. UABIUTY FOR
INCIDENT AL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSEL Y EXCLUDED.
Some
states
and
provinces
do
not
allow
exclusion
of incidental or consequential
damages,
so
the
above limitation or
exdusion
may
not
apply
to
you. This warranty
gives you specific
legal
rights, and you may also have other rights
which vary
from
state
to
state and province
to
province.
Philips and the Philips Shield Emblem
are registered
trademarks of Koninklijke Philips N.V.
Alterations
in design
and
technical specifications reserved.
"Hue Personal Wireless Lighting" is a trademark owned
by
Signify Holding
B.
V.
Advertisement
