Faq - Ximeta NetDisk Mini MNC10-40 User Manual

®
NetDisk User Manual
For the most recent list of FAQs, please visit http://www.ximeta.com
1. How do I disconnect NetDisk?
To disconnect NetDisk, we always recommend using the Eject option. If you CRTL+click on
the NetDisk on your Desktop, then you will be given an option to Eject the NetDisk. After
that, you can go into NetDisk Admin and Disable your NetDisk.
If you are using USB, then Ejecting the NetDisk is all that is needed.
2. I have installed the Mac Drivers and NetDisk will not Enable.
Make sure you have the latest drivers, available at www.XIMETA.com
Please check the following:
Verify that your cables are plugged in correctly and that you have a link on the switch
where NetDisk is plugged into.
Make sure that it is formatted to a file system that your Mac can recognize.
When plugged in via NDAS (Ethernet), please try enabling Read Only mode and reboot
your Mac. It should show up on your desktop as a Hard Drive.
Try plugging it in via USB to see if it is recognized. If that works, then try reinstalling the
NetDisk software.
If it still does not mount, then try formatting the NetDisk again via USB and retry Enabling
the drive.
3. How should I format NetDisk?
It is recommended to format NetDisk to Mac OS Extended format. If you also have a Win-
dows computer as well, and would like to use it between the two, then you must format it to
FAT32 for it to be recognized on both computers. You may need a 3
ity to format the entire drive to FAT32.
XIMETA, Inc
Network Direct Attached Storage / NDAS
Chapter 9 FAQ
17
rd party partitioning util-
www.XIMETA.com
®