Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fast Mover FMT626
Summary of Contents for Fast Mover FMT626
- Page 1 FMT626_Product Instructions 14/07/2014 11:05 Page 1 FMT626 Under-body Coating Gun Product Instruction Manual Please keep this manual safe for future reference fastmovertoolsuk.com/mp T: +44 (0)1582 661993 E: sales@fastmovertoolsuk.com W: www.fastmovertoolsuk.com...
-
Page 2: Specification
FMT626 Instruction Manual IMPORTANT Please read through this Manual carefully before using the FMT626. This tool must only be used for spraying and within the parameters outlined in this manual. All users of the equipment should be trained in any risks associated with the products they are spraying or using as spraying and finishing aids. - Page 3 Repairs carried out by unauthorised repair agents will invalidate the warranty unless you have been given specific permission by Fast Mover Tools on a case by case basis only. Do not use this tools whilst under the influence of drugs, alcohol or intoxicating Fast Mover Tools Limited T: 0044 (0)1582 661993 E: sales@fastmovertoolsuk.com...
- Page 4 Keep the nozzle 200-300mm from the surface and spray evenly from side to side or up and down. Spraying at an angle will lead to paint runs. Use smooth, even strokes. When spraying large Fast Mover Tools Limited Unit 1 Frenchs Avenue, Dunstable, Bedfordshire, LU6 1BH, United Kingdom...
-
Page 5: Maintenance
- Clean other sections of the gun with the brush soaked in thinner or with a waste cloth. - Always change to air cap, fluid nozzle and needle as a matched set. - Lightly lube all moving parts with a non-petroleum based lubricant. Fast Mover Tools Limited T: 0044 (0)1582 661993 E: sales@fastmovertoolsuk.com W: www.fastmovertoolsuk.com... -
Page 6: Troubleshooting
2 Adjust fluid or pattern knobs Heavy centre spray pattern 1 Paint viscosity too high 1 Adjust viscosity of paint 2 Fluid output too low 2 Increase fluid output Fast Mover Tools Limited Unit 1 Frenchs Avenue, Dunstable, Bedfordshire, LU6 1BH, United Kingdom... -
Page 7: Parts Diagram
FMT626/16 Needle valve FMT626/17 Valve spring FMT626/18 Air Inlet FMT626/19 Screw FMT626/20 Air adjustment knob FMT626/21 Range block FMT626/22 O-ring FMT626/23 Valve stem FMT626/24 O-ring FMT626/25 Open ring Fast Mover Tools Limited T: 0044 (0)1582 661993 E: sales@fastmovertoolsuk.com W: www.fastmovertoolsuk.com... -
Page 8: Warranty
Always dispose of tools in accordance with local authority guidelines. © 2014 Fast Mover Tools Limited. This document is copyright and is not to be copied, circulated, distributed or shown to anyone other than the intended recipient without the express permission of the directors.