C O N T E N T S General Information Limited Warranty (USA Only) Safety Guidelines Overview Setup Wireless Remote Operation Cleaning, Maintenance, and Troubleshooting Specifications Dimension Drawings...
G E N E R A L I N F O R M AT I O N INTRODUCTION Please read and understand all instructions in this manual carefully and thoroughly before attempting to operate these products. These instructions contain important safety and use information. UNPACKING The products in this kit have been thoroughly tested and have been shipped in perfect operating condition.
ADJ Products, LLC Service Department at 800-322-6337. Send the product only to the Eliminator Lighting factory. All shipping charges must be pre-paid. If the requested repairs or service (including parts replacement) are within the terms of this warranty, Eliminator Lighting will pay return shipping charges only to a designated point within the United States.
S A F E T Y G U I D E L I N E S For Your Own Personal Safety, Please Read and Understand This Manual Completely Before You Attempt To Install Or Operate This Unit! This fixture is a sophisticated piece of electronic equipment. To guarantee smooth operation, it is important to follow all instructions and guidelines in this manual.
O V E R V I E W Fog Fluid Resevoir Cap Fog Emitter LEDs Remote Fluid Level Indicator Press for For use with Manual Fog wired remote Emission (Not Included) FUSE...
S E T U P Fluid Level Sensor: This device is equipped with a fluid level sensor for your convenience. When the fluid reservoir contains an adequate amount of fluid, the sensor LED will remain steadily lit. If the fluid level becomes low, the LED will flash to alert you.
W I R E L E S S R E M O T E O P E R AT I O N Always be sure to maintain an adequate supply of ADJ Brand Fog Juice in the fluid reservoir. Running the fog machine dry will cause pump failure and or clogging. This is the largest cause of failure in fog and haze machines.
C L E A N I N G , & M A I N T E N A N C E WARNING! DISCONNECT UNIT FROM POWER BEFORE PERFORMING ANY CLEANING OR MAINTENANCE PROCEDURES! ALWAYS ALLOW THE FIXTURE TO COOL FOR AT LEAST 15 MINUTES BEFORE PERFORMING ANY CLEANING OR MAINTENANCE! FUSE REPLACEMENT To replace the fuse, first, disconnect the unit from its power source and detach the power cord.
S P E C I F I C AT I O N S Features: • 750W professional vertical Fog Machine • Light Source: 6 x 3-Watt LEDs, (2 Red, 2 Green, & 2 Blue LEDs) • Convenient carrying handle • Low Fluid LED Indicator on rear •...
Page 12
D I M E N S I O N S Drawings not to scale 8.33in. [211.6mm] 11.81in. [300mm] 8.49in. [215.6mm] 12.01in. [305mm] 12.88in. [327mm] 8.35in. [212mm]...
Need help?
Do you have a question about the VF VOLCANO EP and is the answer not in the manual?
Questions and answers