Vox CGL6V17IX Operating Instructions Manual page 7

Fix the brackets:
Drill holes at the marked points with a 10 mm drill bit. Insert the

Wall Plugs into the holes.

Fix the Screws (5 x 50) bracket 6 with 2 screws

supplied with the hood at the horizontal line B.
 Chimney fixing bracket 9 with 2 screws 6 (ST5x50)
supplied with the hood at the horizontal line D.
Fix lower decorative chimney
Fix the exhaust pipe on the hood body.

Connect chimney and hood body with 2 screws 8.

Connect chimney fixing bracket 9 and chimney with

2 screws 8.
Hook the hood body
To mount on the wall, drill two 10mm.

Insert two plastics wall plugs(supplied) into the holes.

Insert two screws (ST5*50) 6 into the upper two plastic wall

plugs, and tighten them leaving 3mm ,protruding from the Wall.
Mount the hood on the top screws, Insert the bottom

screws and fully tighten all the screws.

Remove the filter from the inside of the hood body, fix the
screws 6 to Wall Plugs 7 at the points (4).
CONNECTIONS
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney
using either a flexible or rigid pipe ɸ 150 or ɸ 120 mm, the choice of
which is left to the installer.
If to install a ɸ 120 mm air exhaust connection, insert the reducer

flange 3 on the hood body outlet.
Fix the pipe 4 in position using sufficient pipe clamps (not supplied).

Remove possible charcoal filters.

Right
6
9
Wrong
8
D
9
C
2XScrews
(ST5*50)