Sony ICF-7600D Operating Instructions Manual page 11

DIRECT TUNING
If you know the frequency of a station to be received, you can tune In
the station easily by direct tuning.
The numbers in the illustration refer to the sequence of operation.
Set the MAIN POWER switch to ON.
Press the ON button.
Press elther or [AM], input the frequency of the station to be
received and then, within 5 seconds, press [EXECUTE]. The station
will be tuned in.
Refer to "How to input a frequency to the keys".
4 Tune correctly with the FINE TUNING control, if necessary.
See page 22.
5 Adjust the telescopic antenna for FM/SW reception. Rotate the set
horizontally for LW/MW reception. See page 14.
6 Adjust the volume with the VOLUME control and tone quality with
the TONE control.
NEWS: for listening to news
MUSIC: for listening to music
с ~
HOW TO INPUT А FREQUENCY ТО THE KEYS
The frequency range of this radio is: |
FM: 87.6 to 108.0 MHz (type 1 model), 76.0 to 108.0 MHz (type 2 model)
AM: 153 to 29995 kHz
Type 1 model: for France
Type 2 model: for other countries у
Press either or [AM], and the counter keys, then press[EXEGUTE].
The station will be tuned in.
Note: Press within 5 seconds after pressing the counter
keys. If you do not, the previous station will come back again.
The frequency which this radio receives is displayed by the following
allocation depending on the broadcast band. This happens because
the frequencies are allocated at the intervals shown below. Therefore,
if you input a frequency not at these intervals, the frequency just below
will be tuned in and be displayed. :
For example, if you input AM 1,000 kHz with the tuning interval set to
9 kHz, AM 999 kHz will be tuned In and be displayed.
FM: 0.1 MHz SW: 5kHz
MW: SkHz * LW: 3kHz
* This tuning Interval із preset at the factory but can be changed to 10kHz by
switching the 9kHz/10kHz selector in the computer back up/clock battery
compartment. See page 18.
15