Advertisement
SAFETY INSTRUCTIONS
This manual has safety information and instruc-
tions to help users eliminate or reduce the risk
of accidents and injuries.
RECOGNIZE SAFETY INFORMATION
This is the safety-alert symbol. When you see
this symbol in this manual, be alert to the poten-
tial for personal injury.
Follow recommended precautions and safe op-
erating instructions.
UNDERSTAND SIGNAL WORDS
A signal word , WARNING OR CAUTION is
used with the safety-alert symbol. They give the
level of risk for potential injury.
Indicates a potentially haz-
ardous situation which, if not avoided, could re-
sult in death or serious injury.
Indicates a potentially haz-
ardous situation which, if not avoided, may re-
sult in minor or moderate injury.
When used without the safety
alert symbol indicates, a potentially hazardous
situation which, if not avoided, may result in
property damage.
Read and follow all safety information and in-
structions.
GENERAL INSTRUCTIONS
These instructions must be read and under-
stood before installation of this kit. This kit
must be installed by a Dometic Service Cen-
ter or a qualified service technician. Modifi-
cation of this product can be extremely haz-
ardous and could result in personal injury or
property damage.
Tools Required:
Phillips Screw Driver
Socket Wrenches
Step Ladder
Kit Contains:
3310332.000(X) Top Bracket
3310287.002 Electronic Kit
4 ea #10-32 Screws
3310656.016 Instructions
A. Procedure:
1. Open awning 8 - 12 inches.
2.
Remove the four #10-32 phillips screws that se-
cure the right hand top mounting bracket in the
back channel. See Fig. 1.
FIG. 1
Remove 4
#10-32 Screws
3. Remove the top Bracket and replace it with the
new bracket provided. See Fig. 2.
FIG. 2
4.
Reinstall the four #10-32 screws with the new
screws (provided). Be careful not to strip out the
screws.
B. Replace Wind Sensor
1. Fully extend the awning.
2. Turn off the 12 VDC power supplies.
Disconnect the positive (+) 12 volt DC Ter-
minal at the supply terminal. Damage to the
equipment could occur if the 12 volt DC is
not shut off.
2
+
+
Advertisement
