HP 9114A Manual page 8

Installation
On some disc products, HP may qualify other non-HP media.
When tested, this media met HP specifications. However, HP
does not warrant or support this media and cannot control
changes in its specifications or quality. The selection and use
of such products is the customer's responsibility. HP reserves
the right to exclude from warranty and maintenance agree-
ment coverage any repairs which HP reasonable determines or
believes were caused by the use of media not provided by HP.
HP will upon request provide such repairs on a time and
material basis.
Warranty and maintenance agreement coverage of repairs not
caused by the use of non~HP media is unaffected.
Installing the AC Adapter/Recharger
The power light on the front panel flashes whenever it's time to charge the battery. When you get the low
battery indication, the battery provides a reserve operating time of about five minutes, or a standby time of
about thirty minutes. After the battery voltage drops below a minimum, the drive will not respond to read
or write operations. This is to protect your data.
Figure 2-2. Connecting the Adapter/Recharger
The adapter/recharger can be connected to the disc drive at any time. If you connect the recharger during
read/write operations (disc access light is on), avoid jarring the drive.
Insert the adapter/recharger plug into the recharger receptacle on the back of the disc drive.
Insert the power plug of the adapter/recharger into an AC power outlet.
You can use the disc drive while the battery pack is charging. In fact, it is recommended that you use the
adapter/recharger whenever possible, even when the battery is fully charged.
2-2