AFX DANW0706LAJEN Series Installation Instructions

LED Outdoor Luminaires
Wall Mount
120VAC / 60HZ
INSTALLATION INSTRUCTIONS
CAUTIONS
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED;CE PRODUIT DOIT ÊTRE INSTALLÉ SELON
LE CODE D'INSTALLATION PERTINENT, PAR UNE PERSONNE QUI
CONNAÎT BIEN LEPRODUIT ET SON FONCTIONNEMENT AINSI QUE
LESRISQUES INHÉRENTS.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH
CIRCUIT CONDUCTOR BEFORE INSTALLING.
"CONSULTER UN ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS".
1. Please read and understand this entire manual before
attempting to assemble, install, or operate this light fixture.
2. This fixture is designed for use in a 120VAC / 60Hz fused circuit.
This fixture is not compatible with dimming circuit.
3. Some codes require installation by a qualified electrician.
This light fixture must be properly grounded.
4.
5. Make sure connections are secure using included
connector, crimp-on lugs or other UL approved connecting
devices.
6. Before installation or servicing, turn the power OFF at the circuit
breaker or fuse. Place tape over the circuit breaker switch and
verify power is OFF at the light fixture.
This fixture is intended to be used for general outdoor lighting in
7.
dry, damp, or wet locations. For wet locations, fixture must be
mounted at least 48 inches above ground level.
8.
MIN 90 °C SUPPLY CONDUCTORS;
"LES FILS D'ALIMENTATION 90°C MIN" .
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
MOUNTING
Page 1 of 2
1.
2.
3.
Wago
4.
5.
Model # DANW0706LAJENxx
Remove the mounting plate (D) from the back of the fixture by
loosening the set screw (C) using the Allen wrench (DD). (fig.1)
A
C
DD
Route the junction box wires through the large center hole in the
mounting plate (D).
Align the holes on the mounting plate (D) with the holes on your
junction box. Use two #8 screws (AA)to secure it. Please make
sure the "TOP" is upwards.(fig.2)
AA
Place the small sphere head of the hanger wire (E) between the
back of the small groove located on the bottom of the center hole
of the mounting plate (D).
Ensure the photocell (B) is facing downwardswhen the light fixture
(A) is installed. (fig.3)
D
E
B
A
D
(fig 1)
(fig 2)
D
(fig 3)
8061710 R0