Table of Contents
Advertisement
KV-1412EC
RM-635
.
MANUAL PROGRAMING
With the manual
program
search
system, the channels
you want
can be preset in a desired sequence.
Any channel can be set to any program position. Consult your local
TV listings to find out the active channels in your area.
Make a list of your desired VHF and UHF channels
and arrange
them in a desired sequence.
The program number will be indicated here.
1
Depress © to turn on the TV.
Press the + or — PROGR button to select the number of the program position
to which the channel is to be preset.
program position
For higher-numbered -
AS
RESET button
lf this button is pressed, the set will be automatically tuned to a fre-
quency below channel E2.
lf you want to skip a particular program
position when
scanning
with the PROGR
buttons on the Remote
Commander,
press
the
RESET button when the indicator shows that position.
For lower-numbered program position
to locate a VHF channel E2 - U20
to locate a UHF channel E21 - E68
just press the SEARCH
button again.
Repeat steps 2 and 3 for all the desired channels.
Press the RESET button and then the VHF SEARCH or UHF SEARCH button.
The first channel found will be tuned. Every time you press the SEARCH
button, a
higher-numbered channel is located, so press the button until the desired station received.
6H 0
2B
VHF SEARCH
RESET
UHF SEARCH
A
fF
RESET
@in strong signal areas, tuning may sometimes stop between channels. if this happens,
When the channel is tuned in and memorized,
the program number stops blinking.
Advertisement
Table of Contents
