Related Manuals for WALDIS PRIMOR 2600
Summary of Contents for WALDIS PRIMOR 2600
- Page 1 OPERATING INSTRUCTIONS WALDIS FURNITURE SAFE WITH SAFE LOCK PRIMOR 2600 Furniture safe with electronic safe lock...
- Page 2 Many thanks! Many thanks for choosing Waldis to give you the security you want. Before starting to use your furniture safe, please read these instructions thoroughly! Your contact in case of questions: WALDIS Tresore AG Hofwisenstrasse 20 CH-8153 Rümlang Telephone: +41 43 211 12 00...
-
Page 3: Table Of Contents
Table of contents Overview ..........................1 1.1. Operating controls: WALDIS furniture safe ............. 1 Starting to use your safe ....................1 Operation ..........................3 3.1. Opening the safe ......................3 3.2. Locking the safe ......................3 3.3. Reprogramming codes ....................4 3.4. -
Page 4: Overview
Overview The safe lock PRIMOR 2600 is installed as a standard lock in the WALDIS furniture safe 300 / 400 / 500. 1.1. Operating controls: WALDIS furniture safe Keypad and rotary opening handle The ribbed outer ring of the keypad also functions as a rotary opening handle. - Page 5 3. Connect the 9V ALKALINE block battery to the cable located in the housing of the input unit, and insert the battery into the housing from the front. Avoid jamming the cable! 5. Fold the keypad back down until it engages in the housing of the input unit.
-
Page 6: Operation
Operation 3.1. Opening the safe To open the safe, please keep to the following procedure: 1. First, turn the keypad counterclockwise into the "closed" position to make sure that the lock bolt is relieved of pressure. 2. Enter the code and within 3 seconds after the double acoustic signal, turn the keypad into the "open"... -
Page 7: Reprogramming Codes
3. Gently turn the keypad clockwise to check whether the lock – and therefore the safe – are locked. 3.3. Reprogramming codes NOTE: A new code must always be programmed with the door open, and it must be tested! If the code has been forgotten or can no longer be reconstructed, an emergency opening of the safe must be performed and it must be repaired or replaced at the owner's expense! What the acoustic signals mean 1x signal:... -
Page 8: Replacing The Battery
3.4. Replacing the battery If it is necessary to replace the battery (section 4.1.), keep to the following procedure: 1. Purchase a battery (9V ALKALINE Note the expiration date! block battery) 2. Using the lug positioned on top of the keypad, release the keypad by pulling it out of the input unit. -
Page 9: Malfunctions
Malfunctions 4.1. Battery If there is insufficient battery voltage, a warning signal will sound several times in succession after you enter the code, and the red LED will flash on and off intermittently. If you observe the warnings just mentioned, the 9 V block battery for the lock must be replaced as quickly as possible (section 3.4.). -
Page 10: Basic Rules For Secure Codes
Basic rules for secure codes What you should avoid: • Don't use commonplace sequences such as 000000 or 123456. • Don't use your own birthday, or any car registration numbers or phone numbers. • Don't use a code that you already use elsewhere. How should a code be structured? •...