Table of Contents
Advertisement
ELECTRONIC DIGITAL DOOR LOCK INSTALLATION
Model PL100
Template Set-up
Latch Install
Front Panel Install
Rubber Pad
square spindle
pyramidtimesystems.com
1
2
3
1
Activator
Screw (A)
1
2
stand off screw (C)
3
4
extender screws (D)
5
Measure 1 meter (39.37") from ground and
draw a horizontal line on all three sides of
door
Align *door template with horizontal line
centered in handle centerline and mark drill
holes.
Drill all holes marked using door template.
*Door template included in packaging*
Align latch, adjust activator to center of
hole (2 3/8" or 2 3/4") and secure by using
two (A) screws.
Slide
Note: Check orientation of square
Insert square spindle (side with hole to front
panel), secure by cotter pin and bend pin
leads.
Install screw extenders (D) on front panel and
tighten
Place rubber pad between front panel/door.
Square spindle goes into square hole latch
activator and main wire goes through the
main hole.
Custom Door widths 1 3/4" to 4 3/8"
Install the stand off (C) using special screw (F) and
insert into front panel and tighten with wrench.
I2277 Rev J
7
Advertisement
Table of Contents
