Teac 19 Operating Instructions

Model 19 Walnut
Model 19 Oak
MODEL 19
OAK
Altec Studio Monitor Speaker
designed to meet the stringent
tions of extended frequency
low distortion and wide
that are required for use
broadcasting studios. The
speaker (woofer) produces
frequency response even
exceptionally high power levels.
quency adjustment controls
mid-range) are provided
Studio Monitor Speaker
wide range of acoustic
including audition rooms,
control room monitoring,
mastering rooms, broadcast
toring and playback, auditoriums,
clubs, conference rooms,
churches, and other
applications.
All of these Studio Monitor
tems combine excellent
width, low distortion, uniform
and extended frequency
differences between the
:
al
_1 11
SOUND PRODUCTS DIVISION
Systems are 19 and
specifica­ sensitivity,
response, size. For
dynamic range and acoustic
in recording and tance, the
bass loud­ used. Where
extended low- slight
when driven at acoustic
Two fre­ smaller
selection.
(high and
to adapt the
Systems to a
Wall or Ceiling Mounting
environments,
recording studio
remix studios, For many
Studio Monitor
studio moni­
night­ or suspended
theaters, recommended
professional four V4
in the
washers
Speaker Sys­ loudspeaker
overall band­ the eyebolts.
dispersion System
response. Major eyebolts
larger (Model pound pull) from anchor points in the wall
Spc<'ii\catio}i}i and rojn pout nts aubjcrt to rha npc irittiont
notice. Overall ¡xrformance teiU he maintaitud or improved.
1515 S. Manchester Ave., Anaheim, Calif. 92803
:
al
Model 15 Walnut
Model 15 Oak
MODEL 15
OAK
smaller (Model 15 systems
acoustic output and enclosure
applications where sensitivity
output are of major impor­
larger Model 19 should
space is at a premium
reduction in sensitivity
output is not detrimental,
Model 15 becomes the logical
professional applications
Speaker System is
from a wall or ceiling.
type of installation utilizes
"-20 eyebolts which are secured
sides of the cabinet with
and nuts. The low-frequency
must be removed to
The Studio Monitor Speaker
is then suspended by the
with a lightweight chain
STUDIO MONITOR
SPEAKER SYSTEMS
INSTRUCTIONS
or ceiling. Baffle angle of the monitor may
be adjusted by raising
pair of supporting
points. Figure 1
ceiling-mounted system.
is hung 'bass-side-up',
equalizer assembly
rotated 180 degrees,
maintain a right-side-up orientation.
Optional Mounting Base
If the discriminating
use the Studio Monitor Speaker System
the home environment,
mounting base may
bottom of the cabinet.
optional mounting
Studio Monitor Speaker
side or the top, using
to protect the finish
NOT lay the system
because the grille coverings
aged. Position the
tom of the cabinet,
outward, aligning the
Install the supplied
for Model 19 and No. 10 x IV2" for Model
15 to secure the
Tighten all screws.
are
be
and
and
the
the
hung
A
flat
install
four
(200-
Figure 1. Suspended Studio Monitor
Speaker System
OPERATING
or lowering one
chains at the anchor
illustrates a typical
When the cabinet
the network/
may be removed,
and reinstalled to
listener wishes to
in
the optional
be secured to the
To install the
base, position your
System on one
a carpeted surface
of the cabinet. DO
on its front side,
may be dam­
base against the bot­
rubber feet facing
pilot screw holes.
screws (No. 8 x 2V2"
base to the cabinet.
42-02-033968-02
LITHO IN U.S.A. 278-6/vl