Installation; Transportation; Where To Install Your Unit; Adjustable Plastic Feet - Jeken JRFS556USW-11 Manual

Installation

Transportation

Where to install your unit

Adjustable plastic feet

Door rack

This is the door shelf guide
liner of door
door rack
Do not carry the refrigerator horizontally or by laying it down.
Do not carry the refrigerator by holding the door or handle; the
refrigerator shall be carried by lifting the bottom.
This unit should never be moved alone, two people are required
to safely lift or move your unit.
The refrigerator must be placed on hard, flat ground;
if cushioning is needed, stable, hard, nonflammable cushion
blocks shall be used.
DO NOT USE THE FOAM PACKAGING AS CUSHIONING BLOCKS!
The unit shall be kept away from damp locations where water is
present.Water or dirt should be removed from any surface of the
unit as soon as possible using a soft cloth. This will help prevent
rust and will help your unit run at peak efficiency.
Place the refrigerator in a well-ventilated place, reserve a certain
space around and behind the refrigerator, and do not cover or block
the air grille on the rear cover plate of compressor at the back of
refrigerator; Keep the refrigerator away from heat source or direct
sunlight.
When the refrigerator stays in the packing box, plastic feet are in
tightened state. After carrying it out from the packing box for
placement, please make sure to adjust two front plastic feet until
the height is suitable; just adjust two plastic feet with a wrench or
directly by hand.
Plastic feet and rear rollers must touch the ground to prevent the
refrigerator from movement, vibration or noise.
When moving the refrigerator, adjust plastic feet
counterclockwise to keep them off the ground, and then push the
refrigerator gently to move it.
Disassembly: Hold both sides of the door rack with both hands.
Push it from the side without the guide and push it inward as seen
in the diagram.Push until the edge of the door rack is separated
from the grove of the liner.
Installation :Hold both sides of the door rack with both hands.
Install the buckle of the guide side at first. Then push the other
side inward slightly,the guide will then click into place and the
door rack will be installed. Please make sure it is installed
properly before use.
- 16 -