Timer Programming; End Of Programme - Bosch SMI69U75TW Operating Instructions Manual

en Operating the appliance
4. Release both buttons.
The LED for button # flashes
and the digital display 8 displays
the factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display 8.
To change the setting:
1. By pressing the 3 button, you can
switch the on board computer
(additional programme
information) off :
2. Press START button )".
The set value is saved.
3. Close the door.

Timer programming

You can delay the start of the
programme in 1 hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press the button ` + until
flaching in the timer programming
display X.
4. Press + or – button until the `
displayed time corresponds with your
requirements.
5. Press START button )", timer
programming is activated.
6. To delete timer programming `,
press the + or – button until
indicated on the digital display X.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
24
.
or on : .
is
is

End of programme

The programme ends when the value
appears on the digital display 8
:
and Finished appears in the display
window )2.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
: .... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting :
5. Press programme button # until
the factory set value :
indicated on the digital display 8.
To change the setting,
1. Press programme button 3. Each
time the button is pressed, the set
value increases by one level; when
the value of :
the display jumps back to :
2. Press START button )", the set
value is saved.
3. Close the door.
.
is
has been reached,
(off).