Sage the Steam Zone SFS800 Instruction Book page 12

7. Press the START|PAUSE button to start
steaming. RAPID START will flash on the
LCD screen while the steamer heats up.
8. The steaming level (HIGH/LOW) will flash
when steam is being produced. The timer
will start counting down.
9. After the steaming time is finished, the
steamer will beep three times. If KEEP
WARM was enabled, the steamer will
automatically enter KEEP WARM mode for
15 minutes. When KEEP WARM is finished,
the steamer will beep one time.
Split zone steaming
The steaming area can be divided into two
separate zones to cook foods that require
different steaming level and cooking times.
The LCD screen will display two separate
timers.
1. Fill the water tank with clean tap water.
Ensure the MAX level on the water window
is not exceeded.
2. Place the drip tray and the steaming tray on
the steamer base.
3. Place the food into one or both of the
steaming baskets and close the basket lids.
4. Press the POWER button.
5. Press the SPLIT ZONE button. The LCD
screen will display two steaming levels and
two timers.
6. Set the steaming time for each zone by
pressing the up and down arrows on each
side of the control panel. The steaming time
can be set from 1–45 minutes.
12
7. Press STEAM button on each zone to select
steaming level, steaming with automatic
KEEP WARM or KEEP WARM only.
See page 9 Using STEAM button section.
8. Press the START|PAUSE button to start
steaming. RAPID START will flash on the
LCD screen while the steamer heats up.
9. The steaming level (HIGH/LOW) will flash
when steam is being produced. The timer
will start counting down.
10. After the steaming time is finished for each
zone, the steamer will beep three times.
If KEEP WARM was enabled, the steamer
will automatically enter KEEP WARM
mode for 15 minutes. When KEEP WARM
is finished, the steamer will beep one time.
Synchronised finish
If you have set different cooking times for split
zone steaming, use the SYNC FINISH function
to ensure your entire meal is ready at the same
time. The synchronised finish function will
automatically delay starting the zone with the
shorter steaming time so that both zones finish
steaming at the same time.
1. Press the SPLIT ZONE button for split
zone steaming.
2. Press the SYNC FINISH button to enable
synchronised finish mode.
3. Set the steaming level and time for each
zone and proceed as directed for split
zone steaming.