HP 54501A Getting Started Manual page 21

e Press FREQ [9] entry key.
Select frequency as the measurement to be made.
At least one complete cycle of the
signal must be displayed.
e Press the 1 entry key to select channel 1 as measurement source.
o The result of the frequency measurement is displayed as in figure
below. (Frequency of HP 54502A rear panel calibrator signal is
approximately 500 Hz rather than the approximate 1.515 kHz of
HP 54501A and HP 54503A.)
Ap running
—_— = 4 200 m¥/div
t | offset:-400.0 mV
H | 1.000: 1 de
4 i
ey Z
Atna * ar eres EEEN |
= 1.00000 ms 0.00000 s 166000 ms
200 us/div
frequency (1) 1,51575kHz 1 £7 -400 By
S450 1W34
e Press SHIFT key.
HP 54501A, HP 54502A and HP 54503A Making Automatic Measurements
Getting Started Guide 4-3