Husky HOTC5209B31M Use And Care Manual page 17

Assembly ( continued
Secure the three panels to each other by using four screws (AA)
7.
to the front side of panels first and four on the top of panels.
8. Attach the reinforcement panel (D) to the middle pegboard panel
(C) and workbench by using four screws (BB) .
)
AA
C
D
BB
9.
Using a power drill and 1/8 in. drill bit, drill four holes into the
sides and back of the wood top of the workbench on right
support post (F). Ensure you drill on a level plane and only
3/4 in. depth into the wood top to avoid damage to the mobile
workbench.
1 0.
Repeat step 9 to drill four holes for the other support post (E).
and two holes for panel (D) .
1 1. Secure the right support post (F) to the back of the mobile
workbench using four bolts (CC) and a 10 mm socket.
Secure the post but do not tighten the screws at this
time so that the support post has some movement.
1 2. Repeat step 11 to attach the left support post (E) and using two
bolts (CC) to attach the reinforcement panel (D) .
1 3.
Tighten all screws at this step.
7
Please contact 1-888-HD-HUSKY for further assistance .
D
F
D
F
CC
HUSKYTOOLS.COM
E
E