Xerox Document Centre 50 Specifications

Space Requirements / Service Space Envelope
The dimensions shown below are in inches and are absolute
minimums.
Configurations for Document
Centre ColorSeries 50
Document Centre ColorSeries
50 with or without High Capacity
Offset Output Tray (Base unit)
Base unit + High Capacity
Feeder
Base unit + Mailbox/Sorter or In-
line Stapler Finisher
Base unit + High Capacity
Feeder + Mailbox/Sorter
Base unit + High Capacity
Feeder + In-line Stapler Finisher
Base unit + Edit Pad
Base unit + High Capacity
Feeder + Edit Pad
Base unit + Mailbox/Sorter or In-
line Stapler Finisher + Edit Pad
with or without High Capacity
Feeder
Electrical Requirements
Single Phase
Line to Neutral Service
Receptacles (or equivalents)
Xerox Part Number
Frequency
Power Cord Length
The Western Hemisphere
Document Centre ColorSeries 50
requires sole use of 20 ampere
outlet, which is standard in most
modern office buildings. Consult
the diagram (right side) to confirm
the existence of this outlet in the
proposed installation space
Ground Fault Protection is provided which meets Xerox safety
requirements and exceed the Industry Standards for Information
Technology Equipment.
Installation Considerations
Physical delivery of the Document Centre ColorSeries 50 will be
by a Xerox authorized "Delivery/Removal" carrier. The carrier will
install and perform a functional check of the copier unit. The
carrier will review the "Getting to know your product" package and
provide software/documentation to the customer. The customer
is responsible for connecting equipment on their network.
Carpeted flooring surfaces may require the installation of a
mobility plate to allow the product to be moved during normal
maintenance activities.
Customer Expectation Setting Document for
Document Centre ColorSeries 50
December 12, 2001
Moveable
Width Depth (in.)
(in.)
68.5" 71.5" Room or
86.5" Hallway
98.5" 71.5" Room or
86.5" Hallway
111" 71.5" Room or
86.5" Hallway
141" 71.5" Room or
86.5" Hallway
141" 71.5" Room or
86.5" Hallway
100.5" 71.5" Room or
86.5" Hallway
130.5" 71.5" Room or
86.5" Hallway
176" 71.5" Room or
86.5" Hallway
Western Hemisphere
2 wire, earth ground
16 ampere
105 – 127 volts AC
20 ampere
NEMA Part No. 5-20R
600S3703
60 HZ single phase
10 feet
There should be a minimum of 78 inches (1,981 mm) clearance
from the floor to the nearest overhead obstruction.
The unit weights 477 lbs. (217 kg).
Environmental Requirements
Temperature
Humidity
Heat Emission
Power Consumption
Altitude (above sea level)
Voltage
Low Power Mode Power
Usage
Low Power Mode Recovery
Time
* Stated as an average. Warm up power consumption is 1,600 VA.
Energy Star
The Document Centre ColorSeries 50 is Energy Star certified. This
means that the machine automatically switches to a Low Power mode
after an idle period. After an additional idle period, the device
automatically powers off, saving additional power. The customer can
adjust the "Time to Low Power mode" and the "Time to Auto Power
Off" as described in the System Administration Guide.
Operating Supplies
The Xerox Supplies Marketing Center, 1-800-822-2200 US, 1-800-668-
1099 CAN (English), 1-800-668-0133 CAN (French) is available for
ordering Xerox supplies, including paper and other throughput
material.
US Customers on Metered Price Plans should call Metered Hotline,
U.S., 1 – 800 – 599-2198 for their dry ink and fuser oil.
Item Reorder
#
Dry Ink - Black 6R945
Dry Ink - Cyan 6R946
Dry Ink - Magenta 6R947
Dry Ink - Yellow 6R948
Fuser Oil 8R7975
Staples (for optional 108R152
convenience stapler)
Staples (for optional 8R12724
in-line stapler finisher)
Dry Ink and Fuser consumption will vary depending on image, area
coverage and media
Minimum Maximum
50º F (10º C) 95º F (35º C)
15% RH 85% RH
1,230 BTU/Hr 3,755 BTU/Hr
(Standby) (Running)
800 VA* 1,200 VA*
(Standby) (Running 4-color)
0 10,000 ft. (3,050
meters)
105 127
- 150 Watts
- 30 seconds
Units per
Carton
4 Cartridges
4 Cartridges
4 Cartridges
4 Cartridges
1 Cartridge
3 Cartridges 5000 staples
per cartridge
3 Staple 5000 staples
Packs per pack