Advertisement
User Manual
Electrical
• Please ensure that the required voltage is being supplied at all times.
• The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate over-
current protection. Please refer to the electrical requirements on the unit's nameplate.
• The unit should have its own dedicated outlet.
• Do not use extension cords.
• Ensure the unit is not resting on or against the electrical cord.
• If the unit is not in use for a long period of time, please unplug the unit from the outlet.
• To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.
• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could cause
damage to the compressor.
Functions
Adjusting the Temperature for Dial Controls
The temperature controls are factory-set to maintain an average temperature
of 34° to 45° F. To maintain a different temperature, simply adjust the control
knob located inside the unit. To decrease the temperature (colder), turn
clockwise. To increase the temperature (warmer), turn counter-clockwise.
Defrost System
Galaxy CRG merchandisers use a manual defrost system. Refrigerator coils are kept below the freezing
point (32 degrees Fahrenheit). During compressor downtime, the evaporator fan continues to circulate air
through the evaporator coil. This air circulation raises the coil temperature above the freezing point, melting
any accumulated frost. Run-off water is drained into the evaporator pan and evaporated. To force a manual
defrost: unplug the unit.
Safety / Warning
Please pay close attention to the safety notices in this section. Disregarding these notices may lead
to serious injury and/or damage to the unit.
Attention
• To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet for your
unit.
• Do not use extension cords
• Do not put your hands under the unit while it is being moved.
• When the unit is not in use for a long period of time, please unplug the unit from the outlet.
• After unplugging the unit, wait at least 10 minutes before plugging back in. Failure to do so could cause
damage to the compressor.
- 4 -
TEMP CONTROL
Advertisement
