Advertisement
Installation
Please read this manual thoroughly prior to equipment set-up, operation, and maintenance.
This unit is intended for use in a temperature-controlled environment of less than 75 degrees Fahrenheit and
60% relative humidity.
Important!!! Please Read Before Installation:
• After unboxing, the unit must be kept upright for a minimum of 24 hours in its final installation
location before being plugged in. Failure to do so may cause damage to the compressor and will
void the warranty.
• Make sure that the unit has reached the desired temperature before loading the unit with products.
This unit is meant for keeping cold products cold, not chilling warm products.
• Make sure that there is proper ventilation around the unit in the area where it will operate.
• Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the unit in.
• Do not attempt to remove or repair any component of the unit. Consult an authorized service technician
for servicing/repair.
• Do not hang on doors or sit inside the unit.
• Please read through the manual in its entirety.
• This unit is designed to perform in a temperature-controlled environment at 60% relative humidity. The
unit should be located away from doors, air ducts, and fans that could disrupt airflow and negatively
impact performance.
Cabinet Location Guidelines
• Install the unit on a strong and leveled surface.
- Level the unit by adjusting the screws located on the bottom of the unit.
- If the surface is uneven, the unit may be noisy.
- The unit may malfunction if the surface is uneven.
• Install the unit in an indoor, well-ventilated area.
- Unit performs more efficiently in a well-ventilated area.
- For best performance, please maintain clearance of 6" on the back of the unit.
- Do not use outdoors. For indoor use only.
- Avoid direct sunlight.
• Avoid installation in a high humidity and/or dusty area.
- Humidity above 60% can cause the unit to rust, collect condensation, and may decrease efficiency.
- Dust collected on the condenser coil will cause the unit to malfunction.
• Select a location away from heat and moisture-generating equipment.
- Ambient temperatures above 75 degrees Fahrenheit may cause the compressor to malfunction.
- For optimal performance, this unit should not be used in environments with ambient temperatures
exceeding 75 degrees Fahrenheit.
- The unit should not be placed in areas with an ambient temperature over 90 degrees Fahrenheit
- Equipment malfunctions due to ambient temperatures above 90 degrees Fahrenheit could void
the warranty.
- Do not install this unit inside a closet or alcove.
User Manual
- 3 -
Advertisement
