Assembly; Disassembly; Repair; Damage - Inventini PASCAL User Manual

INSTRUCTIONS
CLOSED
Fig. 1
Fig. 2

REPAIR

www.inventini.com
1. Choose a flat even spot where you want to pitch the sofa.
OPEN
2. Unzip the bag and take out the product.
3. Make sure the pump valve is in the position „CLOSED" (Fig. 1)
4. We recommend first inflating the backrest and then the seat. Use the
pump to inflate the product until you feel it is completely taut (you will
hear the sound of the pump changing) (Fig. 2).
5. Disconnect the pipe of the pump from the product, then turn the pump
o (otherwise the air will escape from the product) (Fig. 3).
1. Block the pump valve in the OPEN position.
2. To remove the air from the product, you can:
• use the pump in ‚pump out' mode (connect the pumping hose to
the opposite side of the pump). When you remove the air from the
Fig. 3
product using a pump, there is no need to block the valve in the
OPEN position as the pump does it automatically. Anyway, by doing
it you will fasten the process of removing the air.
• do it manually by blocking the pump valve in the OPEN position.
3. Pack all elements into the transport bag.
A small hole can be repaired by using repair kit - glue and foil.
If the product foil is damaged:
1. Locate the damage.
2. Degrease the surface.
3. Apply the adhesive to the hole, taking care that the adhesive does
not get inside the product.
4. Apply the foil patch.
5. Wait 60 minutes for the adhesive to fully bond.
There is a possibility of sending the product back to the manufacturer.
We o er paid service for mechanical damage.

ASSEMBLY

DISASSEMBLY

DAMAGE

EN
5