Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AUSTRALIAN MONITOR TRUEBLU
Summary of Contents for AUSTRALIAN MONITOR TRUEBLU
- Page 1 INSTALLATION AND OPERATION MANUAL TRUEBLU Bluetooth Audio Receiver...
-
Page 2: Important Safety Information
IMPORTANT SAFETY INFORMATION READ these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. -
Page 3: Introduction & Contents
Front Panel selector buttons as well as a 3.5mm Rear Panel auxiliary input for wired devices. Bluetooth control Software The TRUEBLU can be programmed using either the free downloadable Bluetooth Dimensions Control software or RS232 to modify Specifications the broadcast name, PIN number and various security features. -
Page 4: Block Diagram
Stereo or mono mode selectable in software • Remote pairing contact • USB-C programming connector • RS232 Comms Port BLOCK DIAGRAM LEFT+ LEFT- Bluetooth MONO RIGHT+ RIGHT- Bluetooth 3.5mm Aux Input RS-232 TX RS-232 RX Pairing Bluetooth Control Software TRUEBLU INSTALLATION AND OPERATION MANUAL... -
Page 5: Front Panel
Press until the LED starts flashing which indicates pairing mode entered. When the device pairs to the TRUEBLU the PAIR LED will stay on. If no device pairs, and the pairing timeout is exceeded, the LED will turn off and the device will enter a non-discoverable state. -
Page 6: Rear Panel
Dedicated pairing input to allow pairing from a remote contact closure. The PAIR input must be switched to GND for at least 150ms to trigger the remote pairing operation. POWER INPUT Accepts +15VDC (50mA) to +24VDC(60mA) input. USB-C CONNECTOR Used to program the TRUEBLU via the PC control software. TRUEBLU INSTALLATION AND OPERATION MANUAL... - Page 7 2. Connect the PC to the TRUEBLU using a USB-C cable (not supplied) Note: 5V power will be supplied via the USB to the TRUEBLU for programming. It does NOT require the +15V to 24VDC input power. Note: The audio playback is not possible with only the 5V USB power connected 3.
- Page 8 DIMENSIONS 143.5mm 114.7mm 104mm TRUEBLU INSTALLATION AND OPERATION MANUAL...
-
Page 9: Specifications
SPECIFICATIONS TRUEBLU Comments AUDIO INPUT CONNECTORS 3.5mm Front Auxiliary Input INPUT SENSITIVITY 200mVrms 3.5mm stereo input OUTPUT CONNECTORS Balanced stereo XLR, unbalanced stereo RCA OUTPUT SENSITIVITY 1Vrms FREQUENCY RESPONSE 20Hz-20kHz ±3.0db THD + N < 0.1% 20Hz-20kHz, 20Hz BW, Unity Gain Max Output, 1kHz, 20kHz BW, >... -
Page 10: Serial Command Protocol
SUCCESS<CR><LF> bt name set Meeting Room 1 SUCCESS<CR><LF> bt config save SUCCESS<CR><LF> Note: The TRUEBLU has a maximum limit of 100,000 save operations. Ensure you do not allow any automated system to save too frequently. TRUEBLU INSTALLATION AND OPERATION MANUAL... - Page 11 NOTES INSTALLATION AND OPERATION MANUAL TRUEBLU...
- Page 12 ENGINEERED BY AUSTRALIAN MONITOR ENGINEERED BY AUSTRALIAN MONITOR Address: Unit 1, 2 Daydream Street, Warriewood NSW 2102 Australia Address: Unit 1, 2 Daydream Street, Warriewood NSW 2102 Australia Website: www.australianmonitor.com.au Website: www.australianmonitor.com.au International enquiries email: international@australianmonitor.com.au International enquiries email: international@australianmonitor.com.au...
Need help?
Do you have a question about the TRUEBLU and is the answer not in the manual?
Questions and answers