Table of Contents
Advertisement
Thermal Sensor Header
(3-pin TR1)
(see p.7, No. 26)
Front VGA Header
(15-pin FRNT_VGA1)
(see p.7, No. 30)
SATA DOM Power
Connector
(3-pin SATAPWR1)
(see p.7, No. 14)
Clear CMOS Pad
(CLRCMOS1)
(see p.7, No. 27)
30
Please connect the thermal
TR1
TR1
sensor cable to either pin 1-2
1
or pin 2-3 and the other end to
GND
the device which you wish to
monitor its temperature.
1
Please connect either end
of VGA_2X8 cable to VGA
header.
Please connect the power cable
on the SATA DOM to this
connector.
N/C
GND
+5V
This allows you to clear the
data in CMOS. To clear CMOS,
take out the CMOS battery and
short the Clear CMOS Pad.
Advertisement
Table of Contents
