Maintenance - Technics SC-EH600 Operating Instructions Manual

Problem
While listening to tapes
Probable cause(s)
Sound is low, intermittent,
Heads are dirty.
or poor quality, noisy,
scratchy, or unsteady.
Dolby noise reduction is set in the wrong
position.
Suggested remedy
Clean the heads.
Set it to match the Dolby NR recording mode.
The deck does not enter the
The erase-prevention tabs are removed from Attach tape to cover the space left by removal
recording mode. tNo raecnHo ...
J
the cassette.
While listening to compact discs
The display will not show
The disc is loaded upside down.
the correct indication. Disc T. ,. -
play does not start when . Thi: * ds-ty._
you press the play button.
Tire disc is scratched._
The disc is badly warped.
The disc is nonstandard.
of the erase-prevention tabs.
Reload the disc.
Wipe the disc with a soft cloth.
Replace the disc with a new one.
Replace the disc with a different one.
There is condensation inside the CD changer Wait for 60 minutes before using the CD
or the CD player.
During one-touch editing
"NO TAPE" appears on the
No tape is loaded into deck 2.
display.
"CHANGE TAPE" appears
Tire protector tab on the tape is broken.
on the display.
changer or the CD player.
Load a tape.
! SC-EH600 only
"ERROR" appears on the
display.
You tried to record tracks from a program
containing more than one disc.
Cover the tab's hole with adhesive tape or use
another tape.
You cannot record programs if containing
tracks from more than one disc. If wanting to
do so, set the tape deck to normal recording.
While using the remote control
0^™~h7."m0te iThebatteries are installed in the reverse Reinsert the batteries in the correct polarity.
-_ The batteries are worn.___ Replace the batteries with new batteries.
The servicer will require all components to service your system. Therefore, should service ever be necessary
bring the entire system. y'
The batteries are installed in the reverse
polarity.
The batteries are worn.
be sure to
Maintenance
■ Maintenance of external surfaces
To clean this unit, use a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap-
and-water solution or a weak detergent solution.
Wring the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, or chemically treated
cloths to clean this unit. Such chemicals may damage the finish of
your system.
■ Tape head care
To assure sound quality for recording and playback, be sure to clean
the heads with a cleaning tape (sold separately) after approximately
every 10 hours of use.
59