Before Recording; How To Advance The Leader Tape; To Erase Recorded Sounds - Technics SC-EH600 Operating Instructions Manual

n
Before recording
[ DECK 2 only I
The unit automatically identifies the type of tape.
Normal position/TYPE 1
O
High position/TYPE 11 i O
Metal position/TYPE IV
O
B
Wind the leader tape forward so that recording can start as soon as
you press the button. This is not necessary if one-touch editing from
CDs.
About the Dolby noise-rcduction system
The Dolby noise-reduction system is designed to effectively reduce
the annoying high-frequency "hissing" noise typical of cassette tapes.
During recording, the system functions to increase the high-
frequency sound level, and then, during playback, that same portion
is weakened to bring it back to the previous level. This unit is
equipped with the Dolby B NR-type.
Dolby B-type noise reduction:
Noise is reduced to about one-third.
Use this system when playing back tapes recorded by the Dolby-B
noise-reduction system, such as prerecorded music tapes, etc.
Dolby noise reduction manufactured under license from
Dolby Laboratories Licensing Corporation.
"DOLBY" and the double-D symbol □□ are trademarks of
Dolby Laboratories Licensing Corporation.
Volume and sound quality in recording
Changes to volume or sound quality are not recorded on tapes at all.
To erase recorded sounds
FI Press INPUT SELECTOR on the tuner/amplifler
to select "TAPE".
H Insert the recorded tape into deck 2.
R Press DOLBY NR so that the Dolby NR indica¬
tor is off.
FI
Press REV MODE to select reverse mode.
O Press • REC PAUSE.
REC PAUSE indicator will light.
f?j Press < or >f whichever side you want to
erase.
Your attention is drawn to the fact that recording pre¬
recorded tapes or discs or other published or broadcast
material may infringe copyright laws.