Linking Compellors (Model 301 And 303) For Stereo Operation; Aural Exciter Initial Settings (Model 303 Only) - Aphex COMPELLOR 300 Operating Manual

5.2 Linking COMPELLORS (Model 301 and 303) for
Stereo Operation
You can tie a Model 301 or 303 for stereo operation through the use of the
LEVELING TIE jack on the rear panel on each COMPELLOR, as shown in
Fig. 5-6.
d
NOTE... Whichever unit is set for the most GAIN REDUCTION will force its action
onto all units connected through the LEVELING TIES.
OUTPUT
()UMW LEVELPSO
SI
rf
Fig. 5-6. Connecting two COMPELLORs (Model 301 or 303) through the rear
panel LEVELING TIES for Stereo Operation.
Plug a 1/4" guitar cord or a standard 1/4" R-T-S patch cord into the two
jacks to cross-link the control voltages. The connection between the two
channels provides tracking and prevents the loss of stereo imaging. Up to
six Model 301's or 303's ( in any combination) can be "mult-ed" together for
multitrack operation.
5.3 AURAL EXCITER Initial Settings ( Model 303 Only)
After you have set the COMPELLOR Controls, set the AURAL EXCITER
Controls to the initial settings shown in Fig. 5-7 (next page).
1. With the AURAL EXCITER 1N/OUT Switch initially in the OUT posi-
tion, adjust the DRIVE Control so that the tri- color LED flashes green to
mostly yellow. On typical program material occasional flashes of red on
peaks are acceptable.
Set the MIX Control at minimum ( full CCW), and press the AURAL
EXCITER IN/OUT Switch to IN.
Operation 5-5