Advertisement
NF-A14 PWM | User Manual
Installation
When installing the NF-A14 PWM on a heatsink, radiator or other devices that use a custom mechanism for fan installation (fan clips, proprietary screws, etc.)
please use this mechanism for installation.
When installing the NF-A14 PWM as a case fan, you can either use proprietary clip systems (if your case features a clip system for fan installation) or the
supplied mounting screws and silicone anti-vibration mounts.
In order to install the fan using the silicone mounts, please first pull the silicone mounts through the mounting holes of the case.
Then put the fan onto the silicone mounts and pull them through the mounting holes of the fan:
Connection
If necessary, you can easily remove the NF-A14 PWM's integrated
The NF-A14 PWM comes with a 4-pin PWM fan connector for fully
anti-vibration pads:
automatic speed control via your motherboard's 4-pin PWM fan headers.
Please note that the fan can also be connected to your motherboard's
3-pin fan headers though. When connected to 3-pin fan headers, the
NF-A14 PWM will run at full speed (unless the motherboard supports
voltage based speed control).
If you're using multiple NF-A14 PWM fans, you can use the supplied
y-cable (NA-YC1) to connect several fans to one PWM fan header. This
way, your motherboard will set all the connected fans to run at the same
speed.
The NF-A14 PWM features a short 20cm primary cable in order to help
you minimise cable clutter in typical applications. If you need a longer
cable, please add the supplied 30cm extension (NA-EC1).
The NF-A14 PWM comes with a Low-Noise Adaptor (NA-RC7) that allows
you to reduce the fan speed from 1500 to 1200rpm. You can either use
the adaptor to set the fan to a fixed speed of 1200rpm (if speed control
is deactivated) or to cap the maximum speed to 1200rpm during PWM
speed control.
Cleaning and Maintenance
Warranty and Support
Fans inside computer cases tend to accumulate dust over longer periods
Even with high-grade products and strict quality control, the possibility
of usage. In order to maintain maximum performance, please clean your
of defects cannot be eliminated entirely. Therefore, we aim at providing
fans regularly using a duster, slightly moist tissue or canned air. Please
the highest possible level of reliability and convenience by offering a
be careful not to use too much force in order to prevent any damage to
warranty period of 6 years and direct, fast and straightforward RMA
the fan. Please don't use a vacuum cleaner as this may apply excessive
service.
force to the fan.
Should you encounter any problems with your NF-A14 PWM, please
In order to ensure flawless operation over many years of usage, the
don't hesitate to contact our support team (support@noctua.at).
NF-A14 PWM's premium grade SSO2 bearing is fully sealed to prevent
the entering of fine dust particles. Please note that the fan is not designed
Please also consult the FAQ section on our website: faqs.noctua.at
to be taken apart by the user. Removing the impeller from the frame will
break the sealing of the bearing and results in a loss of warranty.
www.noctua.at
Advertisement
