Lumens VS-KB21 Quick Installation Manual

VS-KB21/VS-KB21N Quick Installation Guide

1. Product IO Overview

Camera Camera
RS-422 Port
 Ethernet port supports PoE (IEEE 802.3af) power supply
 RS-232/ RS-422 port do not support POE. Please do not connect with POE Switch
Menu Main Button Operation Instructions
2.
When the menu is activated, the Focus button is the main control
button.
 Left/Right rotation: Adjust parameters and navigate the
menu
 Press: Perform "Confirm" action

3. Initial setting

3.1 Use the DC 12V power cord provided with the accessory or
power it with a PoE (IEEE 802.3af) compatible network
switch
3.2 Use the network cable (CAT5e or CAT6) to connect the IP
port on the back of the keyboard to the local area network
3.3 If using power cord for power supply, please press the power
button to turn on the control keyboard

4. Camera Setting

 IP Control
Confirm that the camera and the control keyboard are on the
same network segment, such as 192.168.100.xxx
 RS-232/RS-422 Control
Confirm that the camera control port/protocol/baud
rate/VISCA address and other parameter settings match the
control keyboard
Depending on the camera, the following methods are
supported to adjust the parameters
 Setting Menu: [System]
 Webpage: (According to different webpage versions,
there are two possible paths for settings.)
[Settings] > [Maintenance] > [System Services] >
[Control Port/Protocol/Baud Rate]
[System] > [Control] > [Protocol] > [Baud Rate]
 Camera bottom Dip Switch settings

5. How to Connect IP

5.1 Connect the keyboard and camera to the network switch
*If not connected to a network switch, the default IP for the control keyboard is
192.168.100.100. Please set the camera to the same network segment
OCT. 2023
Ethernet Switch
RS-232 Port Ethernet port
Power Button
Firmware Power Anti-theft
Update Port Supply lock slot
Power Supply Adapter +
USB Disk
Power Cable
www.MyLumens.com
Keyboard
Cat5e
network
cable

5.2 Add the camera to the device list

(1) Automatic search camera
Press [SEARCH] > Select search mode > Select camera
> Save camera to list
 VISCA Over IP
 ONVIF
 NDI (only applicable to VS-KB21N)
(2) Manually add camera
Press [SETTING] > [Device Management] > Set
Control Protocol/IP Address > Save to List

5.3 Confirm CAM ID in the [CAM LIST]

5.4 Call the camera

Press the number and then [CAM] to call the camera.
e.g >

5.5 Preview streaming video

IP connection supports previewing camera RTSP streaming.
Confirm screen display preview icon > press [PVW] > display
camera RTSP streaming image
*Press the [PVW] button again to exit the streaming video screen
Cat5e
network
cable
Router
Camera