Reset Button And Mode Button - M2I MIO-LPG00 Hardware Manual

5.3.3 Private Program Setup
It is a private program supplied by M2I Corporation. It can change the internal settings.
(1) Device Setting: Display the key information of connective device.
(2) LoRa Config: Setting Frequency, TX Power, SF
- Frequency: Setting the frequency of device. Device's rotary switch should be set as 0.
- SF: set between 7~12. Higher number makes data speed down, but longer communication range.
SF select switch of device should be set as 0.
(3) LoRa Data Packet: LoRa communication's AES(Advanced Encryption Standard) setting.
(4) Serial Comm(*Gateway only): Set the mode and specification of serial communication.
(5) OS Upgrade: OS upgrade by connecting USB.
- The device should be Boot mode. (How to: Push the 'RESET' button while the 'MODE' button is pushed.).

5.4 RESET Button and MODE Button

5.4.1 RESET Button
Reset the whole system.
5.4.2 MODE Button
Use when you set the settings automatically.
(1) Push 'MODE' button for 3 seconds of MIO-LPG00, MIO-LPE00 (LoRa LED will blink).
(2) Push 'MODE' button of MIO-LPG00 for 1 second, settings of MIO-LPG00 will send to MIO-LPE00 device, and
settings of MIO-LPE00will be changed same as MIO-LPG00 (and then device will reset).
- Multiple MIO-LPE00 devices' setting can be changed.
M2I Corporation
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea,
Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr
Industrial I/O Wireless Device Hardware Manual
11 / 16