Table of Contents
Advertisement
COVER CRADLE INSTALLATION PREPARATION
STEP 1
INSTALL PREPARATION
•
Refer to (Figure 1.1) for the Left and Right cover
lifter set orientation for (Front to Back) cover
confi guration:
•
On a (Front to Back) cover confi guration, the
Left and Right cover lifter set will attach on
back side of spa (Figure 1.1).
•
The cover will fold toward the back side of
spa.
•
Refer to (Figure 1.2) for the Left and Right cover
lifter set orientation for (Side to Side) cover
confi guration:
•
On a (Side to Side) cover confi guration, the
Left and Right cover lifter set will attach on
left side of spa (Figure 1.2).
•
The cover will fold toward the left side of spa.
•
Align the cover:
•
Position the cover evenly on all spa sides
See (Figure 1.3).
Side to Side
Figure 1.2
3
Front to Back
Back
Warning Label
Front
Figure 1.1
Warning Label
Figure 1.3
The cover warning label must be facing
the front of the spa on (Front to Back)
confi guration or the right side of spa on
(Side to Side) confi guration (Figure 1.1
and 1.2)
STEP 2
LOCATE PLATES
Every Watkins cover has 6 aluminum plates
installed into the foam core hidden beneath the
vinyl on 3 sides of the cover. There are two plates
on the opposite side of the Warning Label and two
on each side of the cover (Figure 1.4).
Warning Label
Only the hidden aluminum plate closest to the
middle of the cover on each side is used for this
cover lifter as well as the two plates in the back
opposite the Warning Label.
There are two predrilled holes on the top of each
plate. Feel around the side of the cover to fi nd the
holes in the plates. Use a fi ne tip marker to mark
the center of the hole for each of the four plates
that will be used (Figure 1.4).
Hidden Aluminum Plate
Figure 1.4
Advertisement
Table of Contents
