Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Gazelle ECT-6022M
Summary of Contents for Gazelle ECT-6022M
-
Page 2: Table Of Contents
Contents I. Product overview........................1 Product introduction ......................1 Components ........................1 Function ........................2 LED fault display ......................2 1.4.1 Low power protection function ................2 1.4.2 Overcurrent protection function ................2 1.4.3 Over temperature protection function ..............2 1.4.4 Overvoltage protection function ................3 II. Technical parameters ......................3 III. -
Page 3: Product Overview
I. Product overview 1.1 Product introduction Electric series hydraulic tools are powered by high-performance lithium batteries and driven by motors. With single stage hydraulic system, automatic pressure relief function and built-in intelligent computer chip. OLED display is easy to read information, also equipped with 2 LED working lights, make work more convenient. -
Page 4: Function
1.3 Function The tool includes an automatic reset device that returns the piston to its original position when it reaches its maximum output force. Manual reset device can manually reset the piston in case of operation error. The head can be rotated 360 degrees to adapt to operations under tight angles or difficult conditions. -
Page 5: Overvoltage Protection Function
When the input voltage of the control board exceeds 24V, it will enter the overvoltage protection state, and the motor drive will be shut down to ensure the safety of the device and the control board. Display alarm content: [OVER VOLT PROT] II. Technical parameters Model ECT-6022M Max output force 60KN Stroke 17mm Crimping range Cu16-300mm²/ Al240mm²... -
Page 6: Electricity Safety
3.1.6 When using safety equipment, masks, goggles, safety hats and insulating shoes should always be equipped to reduce the risk of personal injury. 3.1.7 Dress appropriately and do not wear loose clothes or jewelry. Keep your hair, coat, and gloves away from the turning part. Loose corners, jewelry, or long hair may twist into the turning part. -
Page 7: Battery Charger Operation Guide
IV. Battery Charger Operation Guide 4.1 Battery charging instructions 4.1.1 Charger 1. Green light flashes -- power-on state 2. Steady red light -- charging state (below 80%) 3. Steady red and green light -- charging state (more than 80%) 4. Steady green light-- 100% full 5. -
Page 8: Tool Operation
4.1.2 Attention 1. Batteries can be charged and discharged hundreds of times, but eventually fail. If the tool usage times are shortened, replace the battery. Charge the battery in time. Do not use up all the battery power. This will cause permanent failure of the lithium battery. 2. -
Page 9: Packing List
plastic shell, shorten the service life and damage the battery. Please do not use any chemical cleaning tools. 5.4 To prolong the service life, please replace the hydraulic oil every year. 5.5 If the tool is not used for a long time, please ensure that the piston is in the starting position, clean the tool and apply anti-rust oil. - Page 10 Please properly dispose of all packing materials and removed parts...
Need help?
Do you have a question about the ECT-6022M and is the answer not in the manual?
Questions and answers